Segmental bridge
As its name implies, a
segmental bridge is a
bridge built in short sections (called segments), i.e., one piece at a time, as opposed to traditional methods that build a bridge in very large sections. The bridge is made of
concrete that is either cast-in-place (constructed fully in its final location) or
precast concrete (built at another location and then tranported to their final location for placement in the full structure).
The first segmental concrete bridge, built in 1950, was cast-in-place across the
Lahn River in
Balduinstein, Germany. The first precast segmental concrete bridge, built in 1962, crossed the
Seine River in
France. (FHWA 2003) The first U.S. precast segmental concrete bridge, built in 1973, was built in
Corpus Christi, Texas. (LoBuono 2005) The first U.S. cast-in-place segmental bridge, built in 1974, was built near
San Diego, California.
These bridges are very economical for long-spans (over 100 meters), especially when access to the construction site is restricted. They are also chosen for their aesthetic appeal.
|
Segmental bridge under construction, Ft. Lauderdale, Florida, USA. |
The sequence of construction is similar to traditional concrete bridge building, i.e., build the support towers (columns), build the temporary falsework, build the deck, perform finish work. The principle differences are as follows:# The support towers may be built segmentally. Often this is accomplished using "slip-form" construction, where the falsework moves (slips) upward following sequential concrete "pours." The falsework uses the newly constructed concrete as the basis for moving upward.# After the towers are built, a superstructure is built a top the towers. This superstructure serves as the "launching" point for building the deck. (The deck is often built in both directions away from the tower, simultaneously.)# The deck is now constructed sequentially, beginning at the tower, one section at a time. #*In cast-in-place bridges, the falsework is connected to the previously installed concrete and allowed to cantilever freely. Next, the permanent reinforcing steel and supports are installed. Finally, the concrete is placed and cured, freeing the falsework to be moved. #* In pre-cast bridges, the concrete segment is constructed on the ground, and then transported and hoisted into place. As the new segment is suspended in place by the crane, workers install steel reinforcing that attaches the new segment to preceding segments. Each segment of the bridge designed to accept connections from both preceding and succeeding segments.# The process in step 3 is repeated until the span is completed.
*
Linn Cove ViaductLoBuono, J. (2005). "Assembly required-The instructions for building New Jersey's first segmental bridge." Chicago, Illinois: BridgesMagazineOnline.com. September/October. Downloaded November 2, 2005 from http://www.bridgebuildermagazine.com/.
FHWA (2003). "Task 15.2 Research Synthesis Statement: Segmental Concrete Bridge Design and Construction Practices." Washington, D.C.: Federal Highway Administration. Downloaded November 2, 2005, from http://www.fhwa.dot.gov/BRIDGE/segmental/task152.htm.
*http://www.fhwa.dot.gov/bridge/segmental/index.htm
*http://www.asbi-assoc.org/
*http://www.pbworld.com/news_events/publications/network/issue_57/57_03_murilloj_briefhistoryseg.asp
*http://www.pbworld.com/news_events/publications/network/issue_28/28_16_wahlp_constructionsequence.asp
