AboutCarl Brandt Expertise Will discuss suspensions, lifts, lockers along with tire suggestions. Trail ratings and possible requirements needed for specific type of trails. Safety equipment and what you should carry with you. Certified off-road instructor.
I am not a mechanic, and 4-Wheeling is a hobby, so if I can't answer a technical question it is due to my mechanical knowledge being related to vehicles that I have owned, or have worked on. I do not have manuals on all vehicles.
Experience Experience in the area 40 plus years of 4 wheeling in a variety of vehicles. At the present time, my major off-road rig is a 94 Jeep Wrangler with a spring over and a 3 1/2" suspension lift. This gives me a total lift of 9" or so. I have lockers front and rear. I have removed the track bars, and sway bar for maximum articulation. I am running a stock 2.5 ltr 4 cylinder with a Jacobs ignition along with a K&N air filter. It has 4.56:1 gears with a Dodge NV4500 transmission along with a 3.8:1 Atlas II transfer case. This gives me a final ratio of 95:1 in low gear/low range.
Other vehicles I own, are a 95 Ford F-250 with a 6" lift, posi rear end, 35" MT's, 5 speed with a fuel injected 460 ci engine, and a stock 2000 Grand Cherokee.
Trails I have run are the Rubicon (10 times), Dusey Ershim, Fordyce Creek trail, McGrew trail, several trails in Moab, Utah along with local monthly runs.
Organizations I belong to
President of Lost Coast 4x4's (8 years)
http://lostcoast4x4.org
Blue Ribbon Association
United Four Wheel Drive
Corva
Cal 4 Wheel
Jt writes on 2007-12-24 04:17:46
I have the same problem with my sahara. Im sure its not the breaks, at least on my jeep its not. I think the sound is coming from the drive shaft some where. posibly near the transfer case. I belive its from the slip yoke.The sound could also be coming from the u joins. they might just need to be greased.
David writes on 2008-02-15 21:34:11
Ann,
The exhaust manifold cracking is a common problem with wranglers. It will need to be replaced with a new one that has a flex joint built into it.
The squeaking is most likely caused by your wheel bearings though, regardless of what your mechanic says.
