You are here:

4 Wheel Drive/SUVs/Chevy Blazer Parts

Advertisement

Expert: - 2/8/2005


Question
I have a 1988 S-10 blazer that has possible axle problems. I have an opportunity to acquire a 1994 S-10 Blazer. I really want to keep the '88 Blazer. Are any of the axle parts from the '94 blazer interchangeable with the '88?

Answer
Roscoe,

I'm not familiar with all of the possible replacement alternatives for the S10.  You might contact a local wrecking yard, and ask them about the swaps.  If you are handy with a welder, and know a little about fabricating, you can swap most any parts into another vehicle.  If they have similar suspensions, then the swap should be fairly easy, and possibly a simple bolt in if you replace the whole axle assembly.

Carl

4 Wheel Drive/SUVs

All Answers

Answers by Expert:

Ask Experts

Volunteer

Carl Brandt

Expertise

Will discuss suspensions, lifts, lockers along with tire suggestions. Trail ratings and possible requirements needed for specific type of trails. Safety equipment and what you should carry with you. Certified off-road instructor. I am not a mechanic, and 4-Wheeling is a hobby, so if I can't answer a technical question it is due to my mechanical knowledge being related to vehicles that I have owned, or have worked on. I do not have manuals on all vehicles.

Experience

40 plus years of 4 wheeling in a variety of vehicles. At the present time, my major off-road rig is a 94 Jeep Wrangler with a spring over and a 1 1/2" suspension lift. This gives me a total lift of 7" or so. I have lockers front and rear. I have removed the track bars, and sway bar for maximum articulation. I am running a stock 2.5 ltr 4 cylinder with a Jacobs ignition along with a cold air high flow filter. It has 4.56:1 gears with a Dodge NV4500 transmission along with a 3.8:1 Atlas II transfer case. This gives me a final ratio of 105:1 in low gear/low range. Other vehicles I own, are a 96 Ford F-250 with a 6" lift, posi rear end, 36" Hummer tires, 5 speed with a fuel injected 460 ci engine, an 87 Samurai with an 8" lift, Ford 9" rear end with a spool, Chevy Dana 44 front end with an electric locker, 5.88 gears, 16% reduction in high range and a 6.5:1 low range with 35" Baja Claws, and a stock 2003 Grand Cherokee Overland. Trails I have run are the Rubicon (10 times), Dusey Ershim, Fordyce Creek trail, McGrew trail, several trails in Moab, Utah along with local monthly runs.

Organizations
Lost Coast 4x4's Cal 4-Wheel Corva UFWDA Blue Ribbon Coalition

Education/Credentials
Certified off-road instructor - Certificates in engineering/electronics

©2012 About.com, a part of The New York Times Company. All rights reserved.