You are here:

4 Wheel Drive/SUVs/Grinding when going into 4 wheel high

Advertisement

Expert: - 6/20/2006


Question
I slipped my 1994 suburban into 4 wheel high tonight and going in and coming out of 4 wheel drive it made an aweful grinding noice. Its been doing this off and on for years. Whats going on?

Answer
Billings,

I'm assuming that you are talking about going into low range, and out.  If your rig is an automatic, you need to slow down to 1-3 mph, shift the tranny into neutral, and shift the transfer case into low range rather fast.  This usually will help the transfer case shift smoothly.  Some manufacturers recommend coming to a complete stop before you shift into low range.

If you are talking about high range, then you have a gear, or synchro problem in the transfer case.

See if you can locate an owner's manual, and see the recommended method of shifting your vehicle into low range.

Carl

4 Wheel Drive/SUVs

All Answers

Answers by Expert:

Ask Experts

Volunteer

Carl Brandt

Expertise

Will discuss suspensions, lifts, lockers along with tire suggestions. Trail ratings and possible requirements needed for specific type of trails. Safety equipment and what you should carry with you. Certified off-road instructor. I am not a mechanic, and 4-Wheeling is a hobby, so if I can't answer a technical question it is due to my mechanical knowledge being related to vehicles that I have owned, or have worked on. I do not have manuals on all vehicles.

Experience

40 plus years of 4 wheeling in a variety of vehicles. At the present time, my major off-road rig is a 94 Jeep Wrangler with a spring over and a 1 1/2" suspension lift. This gives me a total lift of 7" or so. I have lockers front and rear. I have removed the track bars, and sway bar for maximum articulation. I am running a stock 2.5 ltr 4 cylinder with a Jacobs ignition along with a cold air high flow filter. It has 4.56:1 gears with a Dodge NV4500 transmission along with a 3.8:1 Atlas II transfer case. This gives me a final ratio of 105:1 in low gear/low range. Other vehicles I own, are a 96 Ford F-250 with a 6" lift, posi rear end, 36" Hummer tires, 5 speed with a fuel injected 460 ci engine, an 87 Samurai with an 8" lift, Ford 9" rear end with a spool, Chevy Dana 44 front end with an electric locker, 5.88 gears, 16% reduction in high range and a 6.5:1 low range with 35" Baja Claws, and a stock 2003 Grand Cherokee Overland. Trails I have run are the Rubicon (10 times), Dusey Ershim, Fordyce Creek trail, McGrew trail, several trails in Moab, Utah along with local monthly runs.

Organizations
Lost Coast 4x4's Cal 4-Wheel Corva UFWDA Blue Ribbon Coalition

Education/Credentials
Certified off-road instructor - Certificates in engineering/electronics

©2012 About.com, a part of The New York Times Company. All rights reserved.