You are here:

4 Wheel Drive/SUVs/Front axle removal Chevy blazer 1997

Advertisement

Expert: - 9/21/2007


Question
On the front driver side what holds the axle in place at the gear box? Is there a bolt or a clip that holds it in there? I can't seem to find what is holding it in place and I need to remove it.

Answer
Wil,

The axle may be held in place at the front differential by a c-clip.  This depends on the type of differential you have.

I would purchase a repair manual for the Blazer at a local auto parts store.  They cost around $20 and are needed for most home repair or trouble shooting.  This manual will give you step by step instructions along with photos of the removal process for your axle.

Carl

4 Wheel Drive/SUVs

All Answers

Answers by Expert:

Ask Experts

Volunteer

Carl Brandt

Expertise

Will discuss suspensions, lifts, lockers along with tire suggestions. Trail ratings and possible requirements needed for specific type of trails. Safety equipment and what you should carry with you. Certified off-road instructor. I am not a mechanic, and 4-Wheeling is a hobby, so if I can't answer a technical question it is due to my mechanical knowledge being related to vehicles that I have owned, or have worked on. I do not have manuals on all vehicles.

Experience

40 plus years of 4 wheeling in a variety of vehicles. At the present time, my major off-road rig is a 94 Jeep Wrangler with a spring over and a 1 1/2" suspension lift. This gives me a total lift of 7" or so. I have lockers front and rear. I have removed the track bars, and sway bar for maximum articulation. I am running a stock 2.5 ltr 4 cylinder with a Jacobs ignition along with a cold air high flow filter. It has 4.56:1 gears with a Dodge NV4500 transmission along with a 3.8:1 Atlas II transfer case. This gives me a final ratio of 105:1 in low gear/low range. Other vehicles I own, are a 96 Ford F-250 with a 6" lift, posi rear end, 36" Hummer tires, 5 speed with a fuel injected 460 ci engine, an 87 Samurai with an 8" lift, Ford 9" rear end with a spool, Chevy Dana 44 front end with an electric locker, 5.88 gears, 16% reduction in high range and a 6.5:1 low range with 35" Baja Claws, and a stock 2003 Grand Cherokee Overland. Trails I have run are the Rubicon (10 times), Dusey Ershim, Fordyce Creek trail, McGrew trail, several trails in Moab, Utah along with local monthly runs.

Organizations
Lost Coast 4x4's Cal 4-Wheel Corva UFWDA Blue Ribbon Coalition

Education/Credentials
Certified off-road instructor - Certificates in engineering/electronics

©2012 About.com, a part of The New York Times Company. All rights reserved.