You are here:

4 Wheel Drive/SUVs/lower transmission line removal at radiator

Advertisement

Expert: - 4/27/2004


Question
when i got ready to remoove my radiator  i discovered the top tranny line was threaded and the lower one was not.havnt experienced this type of connection,does the plastic just compress and the line pull off?
and do i need to replace the plastic retainer after i remoove the line
thanks ernie


Answer
Ernie,

Some of these lines require a special tool for removal, and installation.  I would suggest that you purchase a repair manual (around $20) for your model Jeep.  These manuals give step by step instructions on most repairs, along with a list of any special tools required.  These manuals can come in handy for future trouble shooting.  They can be purchased at most auto parts stores.

  Carl

4 Wheel Drive/SUVs

All Answers

Answers by Expert:

Ask Experts

Volunteer

Carl Brandt

Expertise

Will discuss suspensions, lifts, lockers along with tire suggestions. Trail ratings and possible requirements needed for specific type of trails. Safety equipment and what you should carry with you. Certified off-road instructor. I am not a mechanic, and 4-Wheeling is a hobby, so if I can't answer a technical question it is due to my mechanical knowledge being related to vehicles that I have owned, or have worked on. I do not have manuals on all vehicles.

Experience

40 plus years of 4 wheeling in a variety of vehicles. At the present time, my major off-road rig is a 94 Jeep Wrangler with a spring over and a 1 1/2" suspension lift. This gives me a total lift of 7" or so. I have lockers front and rear. I have removed the track bars, and sway bar for maximum articulation. I am running a stock 2.5 ltr 4 cylinder with a Jacobs ignition along with a cold air high flow filter. It has 4.56:1 gears with a Dodge NV4500 transmission along with a 3.8:1 Atlas II transfer case. This gives me a final ratio of 105:1 in low gear/low range. Other vehicles I own, are a 96 Ford F-250 with a 6" lift, posi rear end, 36" Hummer tires, 5 speed with a fuel injected 460 ci engine, an 87 Samurai with an 8" lift, Ford 9" rear end with a spool, Chevy Dana 44 front end with an electric locker, 5.88 gears, 16% reduction in high range and a 6.5:1 low range with 35" Baja Claws, and a stock 2003 Grand Cherokee Overland. Trails I have run are the Rubicon (10 times), Dusey Ershim, Fordyce Creek trail, McGrew trail, several trails in Moab, Utah along with local monthly runs.

Organizations
Lost Coast 4x4's Cal 4-Wheel Corva UFWDA Blue Ribbon Coalition

Education/Credentials
Certified off-road instructor - Certificates in engineering/electronics

©2012 About.com, a part of The New York Times Company. All rights reserved.