You are here:

4 Wheel Drive/SUVs/steering stabilizer

Advertisement

Expert: - 7/15/2006


Question
I have removed the old stabilizer from my 99 jeep cherokee. the old bolt is still in there, its stuck and i cant pound it out. i tried to heat it up but it wont budge. do you have any sugestions.

Answer
Jason,

If you're talking about the steering damper/stabilizer, as opposed to the stabilizer bar, then normally one end uses a bolt, and the other end is a stud mounted permanently to the stabilizer.  The stud goes through a hole in the tie rod and is held in place with a nut.  

To confirm this for your model, I would purchase a repair manual from a local auto parts store.  These usually cost between $16 and $20.  They are invaluable if you're planning on doing any work on the vehicle yourself.

Carl

4 Wheel Drive/SUVs

All Answers

Answers by Expert:

Ask Experts

Volunteer

Carl Brandt

Expertise

Will discuss suspensions, lifts, lockers along with tire suggestions. Trail ratings and possible requirements needed for specific type of trails. Safety equipment and what you should carry with you. Certified off-road instructor. I am not a mechanic, and 4-Wheeling is a hobby, so if I can't answer a technical question it is due to my mechanical knowledge being related to vehicles that I have owned, or have worked on. I do not have manuals on all vehicles.

Experience

40 plus years of 4 wheeling in a variety of vehicles. At the present time, my major off-road rig is a 94 Jeep Wrangler with a spring over and a 1 1/2" suspension lift. This gives me a total lift of 7" or so. I have lockers front and rear. I have removed the track bars, and sway bar for maximum articulation. I am running a stock 2.5 ltr 4 cylinder with a Jacobs ignition along with a cold air high flow filter. It has 4.56:1 gears with a Dodge NV4500 transmission along with a 3.8:1 Atlas II transfer case. This gives me a final ratio of 105:1 in low gear/low range. Other vehicles I own, are a 96 Ford F-250 with a 6" lift, posi rear end, 36" Hummer tires, 5 speed with a fuel injected 460 ci engine, an 87 Samurai with an 8" lift, Ford 9" rear end with a spool, Chevy Dana 44 front end with an electric locker, 5.88 gears, 16% reduction in high range and a 6.5:1 low range with 35" Baja Claws, and a stock 2003 Grand Cherokee Overland. Trails I have run are the Rubicon (10 times), Dusey Ershim, Fordyce Creek trail, McGrew trail, several trails in Moab, Utah along with local monthly runs.

Organizations
Lost Coast 4x4's Cal 4-Wheel Corva UFWDA Blue Ribbon Coalition

Education/Credentials
Certified off-road instructor - Certificates in engineering/electronics

©2012 About.com, a part of The New York Times Company. All rights reserved.