You are here:

4 Wheel Drive/SUVs/transmission rear seal

Advertisement


Question
I am trying to replace the rear tranmission seal on a 1996 Cherokee Sport. I have removed the drive shaft, but how do I get the rear seal out from here? There is a circular metal housing where the drive went in and I see the seal, but where do I go from here? This seems so simple but I'm stumped. Please advise.

Answer
Pete,

First of all, I believe that you are working on the transfer case, unless you have a 2 wheel drive model.  Seals usually require a special tool for removal, and installation.  I would suggest that you purchase a repair manual (around $20) for your model Jeep.  These manuals give step by step instructions on most repairs, along with a list of any special tools required.  These manuals can come in handy for future trouble shooting.  They can be purchased at most auto parts stores.

  Carl

4 Wheel Drive/SUVs

All Answers


Answers by Expert:


Ask Experts

Volunteer


Carl Brandt

Expertise

Will discuss suspensions, lifts, lockers along with tire suggestions. Trail ratings and possible requirements needed for specific type of trails. Safety equipment and what you should carry with you. Certified off-road instructor. I am not a mechanic, and 4-Wheeling is a hobby, so if I can't answer a technical question it is due to my mechanical knowledge being related to vehicles that I have owned, or have worked on. I do not have manuals on all vehicles.

Experience

40 plus years of 4 wheeling in a variety of vehicles. At the present time, my major off-road rig is a 94 Jeep Wrangler with a spring over and a 1 1/2" suspension lift. This gives me a total lift of 7" or so. I have lockers front and rear. I have removed the track bars, and sway bar for maximum articulation. I am running a stock 2.5 ltr 4 cylinder with a Jacobs ignition along with a cold air high flow filter. It has 4.56:1 gears with a Dodge NV4500 transmission along with a 3.8:1 Atlas II transfer case. This gives me a final ratio of 105:1 in low gear/low range. Other vehicles I own, are a 96 Ford F-250 with a 6" lift, posi rear end, 36" Hummer tires, 5 speed with a fuel injected 460 ci engine, an 87 Samurai with an 8" lift, Ford 9" rear end with a spool, Chevy Dana 44 front end with an electric locker, 5.88 gears, 16% reduction in high range and a 6.5:1 low range with 35" Baja Claws, and a stock 2003 Grand Cherokee Overland. Trails I have run are the Rubicon (10 times), Dusey Ershim, Fordyce Creek trail, McGrew trail, several trails in Moab, Utah along with local monthly runs.

Organizations
Lost Coast 4x4's Cal 4-Wheel Corva UFWDA Blue Ribbon Coalition

Education/Credentials
Certified off-road instructor - Certificates in engineering/electronics

©2012 About.com, a part of The New York Times Company. All rights reserved.