Expert: Steve Guthrie C.C. - 10/13/2008

Question
QUESTION: Hi,
I have an old Ogee clock but the weights were off but the string is there. I noticed that the line was rolled up in back of the gear and not on the spool like it should be. Can you tell me the proper way to run the string for the weights? Also one weight is larger than the other, I assume this is to run the clock movements? Any help would be appreciated. I do not have any springs! Thank you,
KC

ANSWER: Once you have the weight cord(s) extracted, pass them through the slots in the side boards toward the top corners. The strike side(left)will have a roller in it, the cord needs to pass under the roller, not over. Using a crochet hook or similar, catch the cords through the pulley openings in the top of the case. If they are covered, the covers can normally be pulled straight off as they are just held down with two brads each. Once you have the cords feeding through the top of the case, loop them over the pulleys and into the weight channels on the inside of the case. Replace the pulley covers, if any, and then hang your weights. The larger weight does go on the right as you face the clock.

---------- FOLLOW-UP ----------

QUESTION: I really appreaciate the information as it certainly helps. One more problem! The verge came off and I am not sure if there is a spring or a small rod that holds it on. I think once I get this fixed it will run now. Thank you very much,
KC

Answer
The verge fits on a short pin that is located beneath the escape wheel. After placing the verge onto the pin, there should be an L-shaped wire that swivels over to cover the end of the pin to prevent the verge from coming off. Look for that to the right of the pin.