You are here:

Audio Systems/what type of box (sealed or ported) should i use for 2 12" mtx thunder 6000

Advertisement

Expert: - 4/12/2010


Question
what type of box should i use for my 2 12 inch mtx 6000s

Answer
http://www.mtx.com/caraudio/products/manualsQuickInstall/subs/T61244A.pdf

The above pdf data sheet shows all the combinations for box type, size of box and frequency response results for the T61244a model.

You did not give me the model number of your speaker so, if you need another model you can find it in the archives section of the support pages at wwww.mtx.com the factory web page.  It is a good reference for you.  You can than choose the box design for your model speaker based on the size of box and the performance you seek to achieve.

Best wishes.  

Audio Systems

All Answers

Answers by Expert:

Ask Experts

Volunteer

Cleggsan

Expertise

Audio Design Engineer; systems, loudspeakers, cd/dvd players, etc. I am knowledgeable in all high end audio equipment and installations. MAKE SURE YOU GIVE A MAKE AND MODEL NUMBER AND CAR IF IT IS AN AUTO QUESTION. Note: I am getting some who ask good questions that take a lot of time to research but then the questioner fails to read the answer. Please don't ask questions unless you are seriously looking for an answer. If you find an answer to your question otherwise then let me know with your reply. Thank you.

Experience

Have been associated with audio design, standards, testing and component systems for over 40 years.

Organizations
Life Fellow Member of Audio Engineering Society Life Senior Member of Institute of Electronic and Electrical Engineers

Publications
Review technical manuscripts for IEEE Spectrum Write occasionally for high-end audio publications

Education/Credentials
BSEE/MSCS/MBA

Past/Present Clients
Past Employee/advisor to several well known audio products manufacturers

©2012 About.com, a part of The New York Times Company. All rights reserved.