Audio Systems/orion speakers

Advertisement


Question
QUESTION: I just got 2 10" orion hp10d2 speakers what spec.s do i need in an amp to run these

ANSWER: Here are the specs:

Technical Specification
Sensitivity: 85 dB
RMS Power Range : 500 Watts
Peak Power Handling: 1000 Watts
Impedance: Dual 2 Ohm
Diameter: 10 Inch
 Features
Vas.2: 0.62 cu ft
Vas.4: 0.56 cu ft
Sensitivity: 85/ 83dB
Linear Excursion: 14mm
Dimentions: 9"/ 6.5"
Power Handling 500 Watts RMS / 1000 Watts Peak
Machined Custom Die-Cast Basket
Open Loop Motor Design
Metalized Poly Cone and Medium Roll NBR Surround
Tight Small Sealed Box Performance
Custom Tooled Reversible Wrap Gasket and Protective Magnet Boot
Heavy Gauge Wire Terminals
2.5 Inch Voice Coil on Aluminum Former
Priced Per Speaker
Subwoofers are usually sold as a single unit unless otherwise noted.
Authorized Internet Dealer
Warranty: 1 Year Manufacturer warranty.


So you need a stereo amplifier that will drive one ohm loads (putting the dual voice coils in each speaker in parallel).  There are other combinations.  See the crutchfield alternatives at:

http://www.crutchfield.com/S-4WL4xQIO6VC/learn/learningcenter/car/subwoofers_wir

Since the sensitivity is only 85db you need a strong amplifier to drive them.  At least 250 watts/speaker is best.

Good Luck.



---------- FOLLOW-UP ----------

QUESTION: ok im looking at 3 different amps but what is better to go with a 1000 watt 2 channel or a 1000 watt mono amp?]

what is the difference

im looking at

orion CO8001 ..     800 watt mono
kenwood KAC-8105D .. 1,000 watt mono
kenwood  KAC-7205 .. 1,000 watt 2 channel

Answer
Any of them are good.  Choose on features, ease of installation, looks and price.  There is little difference in sound output among them I can assure you.  However, there are differences in sound quality from amp to amp and you can not know without serious auditioning.  Maybe buy from a dealer who will let you exchange if you find, after installation the sound is not to your liking.  If you are a neo-audiophile you may not detect any sound quality differences; it takes experience and lots of comparative listening to become a "golden ear".  

Audio Systems

All Answers


Answers by Expert:


Ask Experts

Volunteer


Cleggsan

Expertise

Audio Design Engineer; systems, loudspeakers, cd/dvd players, etc. I am knowledgeable in all high end audio equipment and installations. MAKE SURE YOU GIVE A MAKE AND MODEL NUMBER AND CAR IF IT IS AN AUTO QUESTION. Note: I am getting some who ask good questions that take a lot of time to research but then the questioner fails to read the answer. Please don't ask questions unless you are seriously looking for an answer. If you find an answer to your question otherwise then let me know with your reply. Thank you.

Experience

Have been associated with audio design, standards, testing and component systems for over 40 years.

Organizations
Life Fellow Member of Audio Engineering Society Life Senior Member of Institute of Electronic and Electrical Engineers

Publications
Review technical manuscripts for IEEE Spectrum Write occasionally for high-end audio publications

Education/Credentials
BSEE/MSCS/MBA

Past/Present Clients
Past Employee/advisor to several well known audio products manufacturers

©2012 About.com, a part of The New York Times Company. All rights reserved.