You are here:
Audio Systems/DVD display
Advertisement
Question
Why is the screen split in two and shown only in black and white. Toshiba DVD SD3750
The only split-screen is when you are using the menu to select titles or scenes when playing a dvd disc. The black and white could be the setting for progressive scan is not set. You can put that to automatic selection by going into the menu and the setup panel. If you have your owners manual it will be found on page 56.
If these settings don't help then the player may be defective and need service at a Toshiba servicing shop. However, the cost of service is often as much or more than the cost of a new player now days ($25 and up), so you must think about that.
Hope this helps.
Related Articles
Answers by Expert:
Cleggsan
Expertise
Audio Design Engineer; systems, loudspeakers, cd/dvd players, etc. I am knowledgeable in all high end audio equipment and installations. MAKE SURE YOU GIVE A MAKE AND MODEL NUMBER AND CAR IF IT IS AN AUTO QUESTION. Note: I am getting some who ask good questions that take a lot of time to research but then the questioner fails to read the answer. Please don't ask questions unless you are seriously looking for an answer. If you find an answer to your question otherwise then let me know with your reply. Thank you.
Experience
Have been associated with audio design, standards, testing and component systems for over 40 years.
Organizations
Life Fellow Member of Audio Engineering Society
Life Senior Member of Institute of Electronic and Electrical Engineers
Publications
Review technical manuscripts for IEEE Spectrum
Write occasionally for high-end audio publications
Education/Credentials
BSEE/MSCS/MBA
Past/Present Clients
Past Employee/advisor to several well known audio products manufacturers
©2012 About.com, a part of The New York Times Company. All rights reserved.