You are here:

Audio Systems/Installing a JVC cd player

Advertisement


Question
Hi, i got a JVC cd player from my friend and he gave me the harness with it, i lost the harness he gave me so i bought a new one, the new one had the clips on both ends and the one he gave me only had it on one end, now i went to go install the radio and noticed that there was no clip coming from where the radio should be, instead it was a bunch of wires, how do i install this radio?

btw i have an 86 Pontiac Firebird

Answer
Hi Eric,
Assuming you have the radios harness the text below will get you sorted,
Good luck Peter
THE FOLLOWING IS THE PROCEDURE I FOLLOW IN A CAR I DON'T KNOW,

You will need;
An AA torch battery
Some paper / masking tape for labels
A pen
Paper to make notes
A 12v test probe, (like a screwdriver with a lead and clip on it and a bulb inside)
(Or a test meter set to 20VDC)

Favourite beverage x 4.

Speaker wires. These are normally twisted together in pairs if you are lucky and are the same colour for each pair but one with a colour trace on, i.e. blue and blue/white, green and green/white. (but not always) Touch a pair across the battery and you will hear a noise on the corresponding speaker, label it (e.g. left rear), continue until all four are identified and labelled.

Drink

Earth one side of your meter or tester to a metal part of the car, probe each wire until you have a wire that is live all the time with the ignition OFF, label this ‘+30’.
Switch on ignition and redo test until you find another previously dead wire now live, this is ‘+15’ accessory.
Switch off ignition and switch on the side / park lights, repeat test until you find a third live ( NOTE, if fitted, not always there), label this ‘dimmer’. Switch off the lights

Drink

You should now have two or three left. One will be earth, (usually black or brown); one could be to an amp and or electric ariel (usually blue or blue/white) and one for phone mute if fitted, (sometimes white but it would go to a phone holder or hands free unit). Connect your DIN plug to the correct wires, test and jobs a good un’.

Two drinks!

DIN connections are.

Speakers

Right rear -,  right front -,   left front -,  left rear-,
Right rear +, Right front +, left front +, left rear +

Power block viewed from cable side

Phone mute (white),/   n/c, /      ariel & amp (blue), /ignition (red)

N/c, / 12vlive, (yellow or orange), / lights, (various colours),/ negative (black)

Audio Systems

All Answers


Answers by Expert:


Ask Experts

Volunteer


Peter G. Lee

Expertise

Accessory installations including audio, security and lighting, general wiring and fault finding. Nothing specific to US car electrics such as ECUs or engine management systems please i.e. how do I get the radio out of a Saturn, we don't have Saturns in Europe so I wouldn't know.

Experience

11 years as a security and audio installer in the U.K. 9 years own company in South West of U.K. installing for a number of high street retailers incluing Trinity in-car centre, Road User, Halfords and A.1. Past advisor to and chairman of Sold Secure initative gloucestershire police. member PACT (partnership against car theft)U.K. police, Kit car builder VW air coole

Organizations
Member of the institute of diagnostic engineers M.I.Diag.E

Education/Credentials
Certified by Clifford, Cobra (U.K.) Serpi Star-Gamel, Moss, Philips, Tracker (Lowjack), Pioneer blue chip installer, Kenwood installer. City and Guilds, A.R.E

Past/Present clients
Over 2,000 between 1988 and 2000

©2012 About.com, a part of The New York Times Company. All rights reserved.