Expert: INSTALLSUPPORT - 9/30/2007

Question
I have a 1995 jeep Cherokee, I replaced the 4.0 engine with another,it ran before i replaced and now it will not run with the new engine. Does the alarm have anything to do with getting power to the coil. Ive replaced the Brain Box and im getting power everwhere else, but im not getting spark from the coil.   HELP!!!!

Answer
Normally, you would insert the key in
the drivers door, turn left, then right
to disarm and reset it. If yours is malfunctioning,
you can disable it for good by doing the following:

The FACTORY ALARM DISARM WIRE IS
green/orange |-| drivers kick panel.

Once Located, splice into this wire with
a simular guage wire, and put it to
a solid chassis ground. This terminates
the alarm functions entirely.

Hopefully this will apply to yours as well.

Have a good eve.

ALARMTEK
CARALARMSTORE.com