Expert: INSTALLSUPPORT - 9/9/2007

Question
QUESTION: today i went to get out of my car i hit the unlock button on the drivers side door and the alarm went off! i tried to start the car and it wont let me. so i disconnected the battery and when i put it back on it still went off. how can i reset the alarm on my car so it quits going off and will let me start it???

ANSWER: I need to determine whether it's a factory alarm
issue or, if it's an aftermarket system you are
dealing with.

Is it: Headlights flashing, car horn honking
and a worded SECURITY" light in the dash flashing?
Or,
is it: flashing parking lights,
an LED in the dash area, and a siren
going off?

Let me know more on this to better
advise you on a course of action
to take, to help you to fix this
situation you're in quickly.

Best Regards,

Robert Martin
CEO/ALARMTEK
CARALARMMAN.com

---------- FOLLOW-UP ----------

QUESTION: it is flashing parking lights and led in the dash and a siren going off. i have no idea what to do!

Answer
Not sure what aftermarket system you have
there, but it's not a factory alarm.
This is what I think is going
on....

The alarm seems to be in long tamper mode.
You will need to reset, and possibly
re program the remotes. That part you will need
your manual for, but the aftermarket alarm
seems to be doing it's job.
At least we know it's installed correctly
which is actually a good thing here.

Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, locate, press and hold in the
valet/overide button, found under the
dash area, (push button, spring loaded)
until the installed LED (the blinking light)
in your dash area goes on solid,
and the siren chirps once.

(Your valet switch might be the toggle
(on/off) type. in this case, key on,
flip switch in opposite direction,
then turn the key off.)

This should reset the alarm, and reset
the grounded relay on the starter wire,
allowing you to start the engine.

At this point, the only thing working would
be the keyless entry from the alarm,
if it came equipped that way.

Just Repeat these steps to place it
back to usable armed mode.
You may get 2 chirps, confirming it,
and the lights may flash twice as well.

That should do it.
If you want to remove it at this point,
take it to your neighborhood installer
for this, or buy the wiring chart
(Go to: www.vehiclewires.com)
for the vehicle, and reverse engineer it wire
by wire, until safely removed.

If it does not work out this way,
you will have to replace the system
with one you know how to operate
and what to expect. Don't want to
get stuck in another bad situation.

Let me know what happens.

ALARMTEK
INSTALLSUPPORT.COM