Expert: INSTALLSUPPORT - 10/2/2008

Question
I need to know how I can arm and disarm my alarm without the remote. I know the door code and I know the alarm works because I armed it (somehow) and I used the key to turn it off (passenger side) this was before I got the code. since I have been using the keypad the alarm no longer arms. any help will be greatly appreciated

Answer
Ok, first try this:
Key in the drivers door, turn left to disarm, then right
to unlock and open the door. If no joy,
there is a fix, but that's a bit of a problem here.
Because yours is a "FACTORY" or, OEM
(original Equipment Manufacturer) "alarm/security" system,
then the disabling procedure info for any given
specific vehicle is now deamed to be too sensitive to
publish here (as suggested by ALLEXPERTS administration.!).

So, to comply, as of March,22 08, this service is no longer
part of the volunteer information I can offer for free here at
ALLEXPERTS.com . Specific OEM/FACTORY alarm disarm/disabling
info is now available ONLY at the WIREWERX.

My installation wiring charts provide the proper wire colors,
polarities, and locations to install a keyless entry,
remote start or, car alarm system into any given vehicle,
or if just trying to disarm/disable your factory/OEM system,
there is a link there to get a tutourial on how to do it yourself
for only $3.99.

I hope you can appreciate the legal reasons behind not
providing this info any longer to just anyone who asks
for general consumption. By doing it this way, I'll
get a record of payment and a name/email address as
a stop gap to help prevent any unauthorized disabling of
your system or anyone elses, by a would be car thief!

Please go to the WIREWERX so I can get you the
info you require to fix your situation.

Hopefully, you can reset on your own first.

Good luck with this issue.

Robert Martin-ALARMTEK AUTO ALARM
The WIREWERX= www.WIRINGCHARTS.com