AboutINSTALLSUPPORT Expertise I Specialize In The Service Application & Functions
Of Aftermarket Car Alarms, Remote Starters & Keyless
Entries. Allthough I Can Not Do Full Installation
Technical Support Here, I will Answer General
Questions On Installation, Or Malfunctioning Systems.
Experience 35 years installation and sales of car alarms and accessories.
Education/Credentials 28 YEARS IN THE SAME LOCATION INSTALLING CAR ALARMS & ACCESSORIES, SCHOOLS & GRADUATED PROGRAMS INCLUDE: CELLULAR ONE QUALITY CONTROL-BELL ATLANTIC MOBILE-IMTL-FLEETILLA TECH COURSES -
SILVER LEVEL MECP-HONDA/TOYOTA SECURITY APPLICATION SPECIALIST - 4 YEARS AT DESIGNTECH INTERNATIONAL TECH SUPPORT DESK - NOKIA TECH COURSE-AAMP & BISHOP ELECTRONIC CERTIFICATES, SKY TRACK 12 VOLT GLOBAL POSITIONING-PRODUCT INSTALLATION-APPLICATION/MASTER CERTIFICATION COURSE & MORE!
Thank You For Stopping By!
PLEASE TAKE NOTE!! I do not provide remote transmitter programming information here!
Question We can not find a toggle switch to stop this mode. And the key fob
does work the doors and locks. What can we do to make the system
inop and still be able to use the key fob.
Ok, an installer would place the velet switch in a semi
hidden area. I'd look under the dash area
for a button or, a toggle switch. When you locate it,
turn on the ignition key, press and hold in the
button (little spring loaded micro button, red or
black possibly), until the alarm chirps 1 time.
This should over ride the system, and only the
keyless entry part, if installed, would still be
operating.
The LED (light emiting diode) light in the dash
should also go on solid.=VALET/OVERIDE
This stops the alarm except for the keyless
entry if installed. Once in Valet mode,
it will allow the car to start and operate
like there was no alarm at all.
The next step is if wanting to remove it,
you contact a local technician to
locate it, and affect neccesary service
for you.
)