Expert: INSTALLSUPPORT - 12/28/2009

Question
I'm installing a CT-3271 with a XXpresskit PKUCG2X bypass.  I have figured out all the wire connections except one.

The CT-3271 install guide says to connect the Door Input in a way as to allow each one of the doors to be detected by the remote starter.

My questions is how to connect multiple wires in a way to achieve this. Best to my info it is a NEGATIVE DOOR INPUT but there is multiple wires in the driver door, Drivers DoorPin Tan/Black and the Passenger/Rear DoorPin Light Blue.  Do I use a splice with a diode for each wire to isolate them or something else ?

Thank You

Answer
Conflict of interest for me here.
I sell this device and don't supply
support for non customers.
However, if you
would, restate this question in my installers
forum at www.installsupport.com ,
my resident technicians there can assist
with this project.

They can go into detailed assistance
you might need on this project that
I can not provide.

Good luck there.

ALARMTEK
CARALARMMAN.COM