AboutINSTALLSUPPORT Expertise I Specialize In The Service Application & Functions
Of Aftermarket Car Alarms, Remote Starters & Keyless
Entries. Allthough I Can Not Do Full Installation
Technical Support Here, I will Answer General
Questions On Installation, Or Malfunctioning Systems.
Experience 35 years installation and sales of car alarms and accessories.
Education/Credentials 28 YEARS IN THE SAME LOCATION INSTALLING CAR ALARMS & ACCESSORIES, SCHOOLS & GRADUATED PROGRAMS INCLUDE: CELLULAR ONE QUALITY CONTROL-BELL ATLANTIC MOBILE-IMTL-FLEETILLA TECH COURSES -
SILVER LEVEL MECP-HONDA/TOYOTA SECURITY APPLICATION SPECIALIST - 4 YEARS AT DESIGNTECH INTERNATIONAL TECH SUPPORT DESK - NOKIA TECH COURSE-AAMP & BISHOP ELECTRONIC CERTIFICATES, SKY TRACK 12 VOLT GLOBAL POSITIONING-PRODUCT INSTALLATION-APPLICATION/MASTER CERTIFICATION COURSE & MORE!
Thank You For Stopping By!
PLEASE TAKE NOTE!! I do not provide remote transmitter programming information here!
Question I took the battery off to charge it and when I put it back on the alarm came on and will not go off, as well as not being able to start my car. I did not buy this car new and never even used the alarm. I do not have the keyless entry or a remote. Please help!! Is there anything at all that I can do to remedy this situation? I cannot take it to a dealership because it won't start!! Help!! I read your other answers to similar situations and putting the key in the door, turning left then right, did not work!!!
Answer Did you also look at the posts concerning VALET-OVERRIDE?
This is what's likely needed here.
Look under the dash area for a button or,
a toggle switch. When you locate it, turn on the
ignition key, press and hold in the button (little
spring loaded micro button, red or black possibly)
until the alarm chirps 1 time. This should over ride
the system, and only the keyless entry part,
if installed, would still be operating.
The LED (light emiting diode) light in the dash
should also go on solid.=VALET/OVERIDE
( if this is a remote starter, the antenna on the
front window glass may also have the over ride
button inset into it.)
This stops the alarm except for the keyless
entry if installed. Once in Valet mode,
it will allow the car to start and operate
like there was no alarm at all.
The next step is if wanting to remove it,
you contact a local technician to
locate it, and affect neccesary service
for you.
