Expert: INSTALLSUPPORT - 3/5/2010

Question
After replacing the battery the alarm system comes on when the last (negative) terminal is put on and tightened down.  It continues to beep with the lights flashing.  The key does not crank the starter when inserted and turned. after waiting maybe 20 seconds or so the beeping stops.  Sometimes the red security light flashes about 3 times per second.  Sometimes it drops to about once per second...still won't crank when key turned. Light stays on when key is inserted.  How do I turn off the alarm and return it to normal operation?

Answer
Hmmm, might need to be evaluated by a tech to
trouble shoot the issue. Until then, to try to disarm it,
look under the dash area for a button or,
a toggle switch. When you locate it, turn on the
ignition key, press and hold in the button (little
spring loaded micro button, red or black possibly)
until the alarm chirps 1 time. This should over ride
the system, and only the keyless entry part,
if installed, would still be operating.
The LED (light emiting diode) light in the dash
should also go on solid.=VALET/OVERIDE
( if this is a remote starter, the antenna on the
front window glass may also have the over ride
button inset into it.)

This stops the alarm except for the keyless
entry if installed. Once in Valet mode,
it will allow the car to start and operate
like there was no alarm at all.

The next step is if wanting to remove it,
you contact a local technician to
locate it, and affect neccesary service
for you.

That should solve the troubles.

Let me know what you discover.

ALARMTEK
CARALARMMAN.COM