You are here:
- Home
- Shopping
- Cars
- Auto Theft Prevention
- Installed car alarm/remote starter......
Auto Theft Prevention/Installed car alarm/remote starter......
Advertisement
Question
I have installed a car alarm/remote start in my vehicle. I press the arm button and it chirps. I try pressing the buttons like it says to start it from the button and it will not even crank. I am sure all wires are correct except the ignition 2. I was wondering why it will not start the vehicle like it was supposed to. The vehicle is a 1990 Plymouth Acclaim LE. The alarm is an after market alarm.
From the notes shown, you will need the second ignition (black/orange)
and the starter wire MUST be on the YELLOW wire off of
the ignition switch.
Then follow the procedure for remote starting
in your manual and try again.
Should have good results.
ALARMTEK
CARALARMMAN.com
Related Articles
Answers by Expert:
INSTALLSUPPORT
Expertise
I Specialize In The Service Application & Functions Of Aftermarket Car Alarms, Remote Starters & Keyless Entries. Allthough I Can Not Do Full Installation Technical Support Here, I will Answer General Questions On Installation, Or Malfunctioning Systems.
Experience
35 years installation and sales of car alarms and accessories.
Education/Credentials
28 YEARS IN THE SAME LOCATION INSTALLING CAR ALARMS & ACCESSORIES, SCHOOLS & GRADUATED PROGRAMS INCLUDE: CELLULAR ONE QUALITY CONTROL-BELL ATLANTIC MOBILE-IMTL-FLEETILLA TECH COURSES -
SILVER LEVEL MECP-HONDA/TOYOTA SECURITY APPLICATION SPECIALIST - 4 YEARS AT DESIGNTECH INTERNATIONAL TECH SUPPORT DESK - NOKIA TECH COURSE-AAMP & BISHOP ELECTRONIC CERTIFICATES, SKY TRACK 12 VOLT GLOBAL POSITIONING-PRODUCT INSTALLATION-APPLICATION/MASTER CERTIFICATION COURSE & MORE!
PLEASE TAKE NOTE!!
I do not provide remote transmitter
programming information here!
Click here For My Alternate Experts Page
©2012 About.com, a part of The New York Times Company. All rights reserved.