You are here:

Auto Theft Prevention/96 mustang engine swap

Advertisement


Question
I have a 96 mustang 3.8 v6 recently swapped eng and trans that was bad with eng. and trans. out of a 95 stang 3.8 now car wont start turns over fine but no spark not sure if factory anti theft system problem the car has the chip you plug in under steering column checked all connections everything in place any help please.

Answer
This issue here is likely to be that Ford
will need to re scynch the PATS system.

The fuel rail transoponder cut off circuit
is now without the correct code and needs to be
redone. You are almost there. Have it towed
to Ford service and get this part done and
you should be all set if the replacement
work on the engine was right.

GL.

ALARMTEK

Auto Theft Prevention

All Answers


Answers by Expert:


Ask Experts

Volunteer


INSTALLSUPPORT

Expertise

I Specialize In The Service Application & Functions Of Aftermarket Car Alarms, Remote Starters & Keyless Entries. Allthough I Can Not Do Full Installation Technical Support Here, I will Answer General Questions On Installation, Or Malfunctioning Systems.

Experience

35 years installation and sales of car alarms and accessories.

Education/Credentials
28 YEARS IN THE SAME LOCATION INSTALLING CAR ALARMS & ACCESSORIES, SCHOOLS & GRADUATED PROGRAMS INCLUDE: CELLULAR ONE QUALITY CONTROL-BELL ATLANTIC MOBILE-IMTL-FLEETILLA TECH COURSES - SILVER LEVEL MECP-HONDA/TOYOTA SECURITY APPLICATION SPECIALIST - 4 YEARS AT DESIGNTECH INTERNATIONAL TECH SUPPORT DESK - NOKIA TECH COURSE-AAMP & BISHOP ELECTRONIC CERTIFICATES, SKY TRACK 12 VOLT GLOBAL POSITIONING-PRODUCT INSTALLATION-APPLICATION/MASTER CERTIFICATION COURSE & MORE!

Thank You For Stopping By!
Click Here To Go To My 12 Volt Installers Forum!
PLEASE TAKE NOTE!!
I do not provide remote transmitter
programming information here!

CLICK HERE!

Click here For My Alternate Experts Page

©2012 About.com, a part of The New York Times Company. All rights reserved.