Expert: INSTALLSUPPORT - 11/17/2007

Question
WOULD LIKE TO KNOW HOW TO DISARM THE SYSTEM. LOST KEYLESS ENTRY PAD,ALARM IS ACTIVATED AND CANNOT SHUT IT OFF. UNPLUGGED ALARM UNDER DASH,BUT FUEL PUMP IS STILL DISABLED. THANK YOU.

Answer
Normally, you would insert the key in
the drivers door, turn left, then right
to disarm and reset it. If yours is malfunctioning,
you can disable it for good by doing the following:

Put the alarm module back in. Then
find the FACTORY ALARM DISARM WIRE
It is the green/orange located in the driver's
kick panel.

Once Located, splice into this wire with
a simular guage wire, and put it to
a solid chassis ground. This terminates
the OEM alarm functions entirely.

However, at this point, this car would be exceedingly
easy to steel, so I suggest you get an aftermarket
alarm system to protect it from here on in.

If you have already have an after market alarm
however:

(SIREN & FLASHING PARKING LIGHTS= AFTER MARKET
or is it:
CAR HORN & FLASHING HEADLIGHTS= OEM-FACTORY)

Then look for the over ride/valet button under
the dash area, probably to the left leg region,
drilled into the plastic kick panel.

Then it's: KEY ON, PRESS AND HOLD IN BUTTON FIRMLY
UNTIL THE SIREN CHIRPS ONCE, AND THE PARKING LIGHTS
FLASH. THEN KEY OFF.

This is over ride, and the car should start.
The only thing that would work would be keyless
entry if it is installed. The alarm functions
have been suspended.

Let me know which applied to your issue.

Good luck.

ALARMTEK
CARALARMMAN.COM