Expert: INSTALLSUPPORT - 9/2/2007

Question
QUESTION: My Grand cherokee will not start as the immobiliser has engaged so all I get is the buzzer, is there a way to bypass thi to enable me to get it to a workshop? or is there a easy fix
many thaks gary

ANSWER: Need the year.

A.

---------- FOLLOW-UP ----------

QUESTION: Sorry it's 1999 auto

Answer
Alright, normally, you would insert the key in
the drivers door, turn left, then right
to disarm and reset it. If yours is malfunctioning,
you can disable it for good by doing the following:

The FACTORY ALARM DISARM WIRE IS
lt. green/orange. The factory alarm disarm requires
a 463 ohm resistor to ground on the
lt.green/orange wire at the drivers
door lock switch, you MUST use a relay.
See negative relay diagram at www.relayhelp.com

Once Located, splice into this wire with
a simular guage wire, and put it to pin
86 on the relay.

Remove the plastic
covering up the wire packs to access.

That should take out the alarm for as
long as it stays grounded.

A.