AllExperts > Automotive 
Search      
Automotive
Volunteer
Answers to thousands of questions
 Home · More Automotive Questions · Answer Library  · Encyclopedia ·
More Automotive Answers
Question Library

Ask a question about Automotive
Volunteer
Experts of the Month
Expert Login

Awards

About Us
Tell friends
Link to Us
Disclaimer

 
 
 
 
About Skip Bollinger
Expertise
Heretofore, I will NOT answer any mechanical question. I am not qualified and can only offer speculations. You are better served by others that are true Techs. With that being said, please only ask about parts and locating obsolete Auto Parts. Thank you. I have the ability to locate quite a few mechanical parts for American made vehicles fron the 1900`s to present. Some are OEM and some are aftermarket. This would include engine, brake and chassis parts. Body parts and trim are VERY difficult to find but you may inquire. If you need assistance in repair, I have illustrated books for major American manufacturers that show some illustrations BEFORE 1974. If needed, I can supply repair manuals for your specific vehicle. PLEASE REMEBER I'M A PARTS SPECIALIST, NOT A TECH!! Thank you.. Skip

Experience

Past/Present clients
Too many to list but they run from Europe through America and to Australia.

 
   

You are here:  Experts > Industry > Transportation and Logistics > Automotive > fuel gague audi 2.3e coupe

Automotive - fuel gague audi 2.3e coupe


Expert: Skip Bollinger - 2/25/2008

Question
el
fuel gague not working 2.3e audi coupe any ideas

Answer
Stu,
  I'm a PARTS PROFESSIONAL, NOT a Tech but will offer this for your pondering. A fuel gauge is nothing more than an OHM meter. There are 3 things that can affect it's operation, the gauge itself, the wire going from the tank sender to the gauge or the tank sender. When the tank gets low on gas, I would drop the tank and disconnect the wire going to the gauge. With the key "ON", I'd gently "strike" the wire to a clean ground (the frame or body of the car). Have someone watch the gauge on the dash, the needle should move. IF it does, replace the tank sender. IF it doesn't, run a wire from the gauge to a ground and "strike" that wire to see if the needle moves. If it does, replace the wire from the sender to the gauge. IF it doesn't, replace the gauge.
  I'm sorry but this is the best a Parts Professional can do. I can't think of anything else. I hope this helps. Good luck....
Skip

Add to this Answer    Ask a Question



  Rate this Answer
   Was this answer helpful?
Not at allDefinitely              
   12345  

     
About Us | Advertise on This Site | User Agreement | Privacy Policy | Help
Copyright  © 2008 About, Inc. About and About.com are registered trademarks of About, Inc. The About logo is a trademark of About, Inc. All rights reserved.