AboutSkip Bollinger Expertise Heretofore, I will NOT answer any mechanical question. I am not qualified and can only offer speculations. You are better served by others that are true Techs. With that being said, please only ask about parts and locating obsolete Auto Parts. Thank you.
I have the ability to locate quite a few mechanical parts for American made vehicles fron the 1900`s to present. Some are OEM and some are aftermarket. This would include engine, brake and chassis parts. Body parts and trim are VERY difficult to find but you may inquire.
If you need assistance in repair, I have illustrated books for major American manufacturers that show some illustrations BEFORE 1974. If needed, I can supply repair manuals for your specific vehicle.
PLEASE REMEBER I'M A PARTS SPECIALIST, NOT A TECH!! Thank you..
Skip
Experience
Past/Present clients Too many to list but they run from Europe through America and to Australia.
Question how do i replace the transmission fluid in my 94 mustang v6
5 spd
Answer Dallas,
As stated in my Profile, I'm a Parts Professional, NOT a tech but I think I may be able to give you some direction on this question. I am NOT familiar with the transmission but MOST standard transmissions have a "fill hole" on the side. It is usually about 2/3 the way up on the side. I don't know if you have a Warner or a Tremec but either one should have a fill hole.
Usually the space under the car is limited and you can't get the bottle of trans fluid under there. The trick is to buy the bottle of fluid and about 6' of rubber hose that fits the "tapered top" on the bottle. A person standing beside the car holds the bottle while one slids underneath the car. The one underneath takes the hose and puts it in the "fill hole". The one beside the car puts the hose on the "tapered top" and turns it upside down and begins to squeeze the bottle. When the fluid begins to run out the fill hole, you are done. Replace the filler plug, put the plastic cap on the tapered top of the tranny fluid and go have a beer.
I hope this helps. Please remember, I'm a Parts Professional, NOT a Tech so if I'm wrong, don't hammer my chops, Okay?? Good luck..
Skip
