You are here:

BMW Repair/driveshaft mounting bushing

Advertisement

Expert: - 9/8/2009


Question
how do i replace the driveshaft mounting bracket bushing as my 1984 bmw 528e has a very loud thump/bang on the floor board when you take off in 1st or any gear till the car gets rolling then the thump stops. thank you for your help

Answer
You first need to remove the exhaust,the exhaust shield then you can see the driveshaft.The center bearing is removed with a 13mm wrench.The front shaft are either 17-19mm.The nut that holds the two sections together needs to be loosened and make sure you mark it to make sure it is installed the same way it was removed.

BMW Repair

All Answers

Answers by Expert:

Ask Experts

Volunteer

Don Berlan

Expertise

ASE Master Mechanic for 25 years. Can help with all aspects of BMW repair. I especially enjoy driveablity problems, mechanical or electrical.

Experience

I have been an ASE Master Mechanic for 25 years.I have worked in many dealearships although BMW's are my favorite.I now have my own shop,specializing in BMW's.I have autocrossed and even gotten into mud running with my 4x4.(I am NOT a teacher and don't claim to know everything about the cars I never see.I hope to help you with your repairs and do expect some knowledge on your side.)

Education/Credentials
CMVTI, Auburn Maine

©2012 About.com, a part of The New York Times Company. All rights reserved.