You are here:

BMW Repair/blower motor resistor

Advertisement


Harold wrote at 2013-10-23 18:57:45
if you only have high speed the chances are good that your resistor pack safety  contacts are not making good contact. remove the resistor pack by pulling up and out. if the resistors look good then turn the pack over and use emory paper or a small fingernail file to freshen the contacts on the safety switch. this should restore your lower blower speeds. harold the kraut


BMW Repair

All Answers


Ask Experts

Volunteer


Emanuel Istudor

Expertise

I can answer just about any kind of install / service question on BMW vehicles (specialize in E36).

Experience

5 years

©2016 About.com. All rights reserved.