You are here:

Bowling/Finger and thumb pitches

Advertisement


Question
I am 67 Have been using an extended Pro Release for years. I recently got a ball drilled measured off the release. My specs: 4/1 sixteenth span to both fingers, 0 finger pitch, 1/4wd, 1/8 under thumb. I have a tendancy to squeeze the ball Should I consider 3/8 fwd thumb? Also my middle finger hits against the release. would reverse pitch help? If so what range? Lastly someone recommended the Storm Gadget would it help the middle finger problem?  Thanks?

Answer
The Gadget would not be any different than what you are wearing concerning your middle finger.
When you have your ball fitted do you wear the pro release?  If not,  you need to do that because that will change your measurements.  That could be where the squeezing is coming from.
Reverse in the finger may help, but if check the span with your pro release on.

Good luck,
Chip

Bowling

All Answers


Answers by Expert:


Ask Experts

Volunteer


Chip Aki

Expertise

Ball drilling/fitting, Layouts, coaching related questions, any. USA Bowling Bronze Certified Coach, International Bowling Pro Shops and Instructors Assocation member, 15 years Experience in ball drilling, Storm Staff member.

Experience

Team USA State Champion Indiana'87 and Lousiana '97, National Collegiate Championship Wichita State '87, Ky state Singles Champion '99,Team USA National Finalist '97,'98, USBC Open Singles Champion 2007 (814 series)

©2012 About.com, a part of The New York Times Company. All rights reserved.