Expert: Chip Aki - 3/29/2007

Question
Hey Chip...I just purchased my fourth ball...Its a brunswick fury...I was wondering whats the best drilling pattern/layout for me?...Im a stroker with an average ball speed of 16 mpg...My revs are medium to low...Thanks

Answer
The coverstock on the Fury is very aggressive.  I would think you would want to go with a pin above the ring finger to get the ball to retain some energy down the lane.  However, if you want to the ball for heavy oil, then placing the pin below the ring finger would work.  Place the CG right of the center of grip, but not far enough to require an extra hole.

Good luck,
Chip