Expert: Jim King - 10/6/2006

Question
When laying out a ball for drilling and instructions say 4" and 4" for your pin and cg placement from your PAP, what would you do if the person your drilling the ball fors PAP is only 3 3/4" right and 1" up. How would you compensate for this PAP position?

Answer
Without seeing the release, its hard to say, but I'm assuming a spinner style release. It also depends on what ball you are putting it on, but as a general rule, I would go 3 1/2" and stack it. That way, if it is a mb ball, the mb will be below the thumb.