Expert: Eileen Cronk - 4/13/2009

Question
i have a dresser that I bought at a yard sale in a very good condition,I would like to change the stain color,the present color is brownish tone,im more incline toward a dark mahogany tone,I now that I can not sand the finish off because I might go through the thing layer of veneer,I would like to know if I have to identify what type of finish was apply after the staining job,so I can get rid of it and then apply my new stain color,Could you please help me with this matter?Your answer would be very much appriciated.Thanks.Yovany

Answer
Hi Yovany
Nice to  hear from you.
You are right that you cannot sand the finish off of this dresser before restaining.
The correct and only way to restain is to remove the existing finish.
You do not need to know what the existing finish is  in order to do this.
Here are my complete instructions and material list.
This will be a great first project and hopefully inspire you to do more.

INSTRUCTIONS FOR STRIPPING YOVANY'S DRESSER
The first thing you must do is assemble the material to do the job.
The stripper is the most important item.  
I am hoping you can get "CIRCA 1850" brand paint and varnish remover in your area.
Here is a link
http://www.jamestowndistributors.com/userportal/show_product.do?pid=1694&familyN...

MATERIAL LIST For the stripping stage.
1 gallon stripper
3 boxes of Bull Dog steel wool in medium grade.
One 3 inch oil based paint brush.
Rubber gloves (like you do dishes with), and a pair of cotton gloves inside the rubber ones.
People react differently to stripper. A lot of people feel heat through the rubber gloves, but I feel cold. Have no idea why.
An empty large coffee can. (for the stripper)
A couple of old tooth brushes.
Lots of old rags (I like t-shirts or cotton but for this first stage whatever you have)
Lots of newspaper to protect the garage floor
LOTS OF VENTILATION..A MUST
That's all you need to get started.
HERES WHAT YOU DO...
Work in sections.
Brush on the stripper with the brush. Stripper will quit working if it dries, so keep it wet till the finish softens.
Then take a rag and wipe this mess off.
Then another coat of stripper, rag off again, then while the wood is still wet, take the steel wool and rub with the grain till the wood is nice and clean.
Depending on the material you are removing, another coat of stripper is often needed but you will know this as you progress into the job.
Use the toothbrush in crevices.
Thats all there is to it ...move to another section and continue.
No other prep is necessary...and DO NOT SAND
When the stripping is complete, stain with Minwax stain applied with a rag, then 3 or 4 coats of low lustre tung oil also applied with a rag.
Please let me know if anything is not 100% clear.
Regards
Eileen