You are here:

Cabinets, Furniture, Woodworks/Refinishing an old cedar chest

Advertisement


Question
Hi.  Can you please provide me with the proper steps to refinish a cedar chest?  I want to take it down to bare wood first.  Can you also tell me if I should use varnish or stain?

Answer
Hi Holli
Nice to hear from you.
If you have never done this work before, this will be a great first project. Your first of many I hope.
The procedure for stripping any wood is the same so here are my instructions.

The first thing you must do is assemble the material to do the job.
The stripper is the most important item.  
I am hoping you can get "CIRCA 1850" brand paint and varnish remover in your area.
Here is a link
http://www.jamestowndistributors.com/userportal/show_product.do?pid=1694&familyN...

MATERIAL LIST For the stripping stage.
1 gallon stripper
3 boxes of Bull Dog steel wool in medium grade.
One 3 inch oil based paint brush.
Rubber gloves (like you do dishes with), and a pair of cotton gloves inside the rubber ones.
People react differently to stripper. A lot of people feel heat through the rubber gloves, but I feel cold. Have no idea why.
An empty large coffee can. (for the stripper)
A couple of old tooth brushes.
Lots of old rags (I like t-shirts or cotton but for this first stage whatever you have)
Lots of newspaper to protect the garage floor
LOTS OF VENTILATION..A MUST
That's all you need to get started.
HERES WHAT YOU DO...
Work in sections. Perhaps one side of the chest at a time.
Brush on the stripper with the brush. Stripper will quit working if it dries, so keep it wet till the finish softens.
Then take a rag and wipe this mess off.
Then another coat of stripper, rag off again, then while the wood is still wet, take the steel wool and rub with the grain till the wood is nice and clean.
Use the toothbrush in crevices.
Thats all there is to it ...move to another section and continue.
No other prep is necessary...and DO NOT SAND
When the stripping is complete, stain with Minwax stain applied with a rag, then 3 coats of low lustre tung oil also applied with a rag.
Please let me know if anything is not 100% clear.
Good Luck and great question
Regards
Eileen



--------------------------------------------------------------------------------


No virus found

Cabinets, Furniture, Woodworks

All Answers


Answers by Expert:


Ask Experts

Volunteer


Eileen Cronk

Expertise

Hi..I can answer most questions about the repairing,stripping and refinishing of all your old furniture and wood items(the things we call antiques)I can give advice about what to buy/avoid at auctions/flea markets. I do not give appraisals on antiques.

Experience

I have been refinishing antiques for the past 30yrs. While I have taken several courses over the years,I have found that "hands on" learning is the best teacher. Perhaps I can help you avoid some of the mistakes I made while learning.

©2012 About.com, a part of The New York Times Company. All rights reserved.