You are here:

Cadillac Repair/brake and signal lights on a cadillac deville

Advertisement

Expert: - 12/10/2009


Question
I have a 1994 cadillac deville and my brake and signal lights do not work. I replaced a bulb and that did not work. I then checked the fuse box and they are all good.What else could it be?

My signal lights a light does come on but it doesn't blink.
What can I DO?


Answer
Hello,

There are many things that could be wrong and without seeing the vehicle all I can do is guess.

As for the brake light problem, could be a connector bulkhead at the firewall leading to the rear harness with a connection problem. Could be a bad turn signal switch inside the steering column.

As for you t.s. lighting, but not flashing, that could be a defective flasher located under the dash.



Rob

Cadillac Repair

All Answers

Answers by Expert:

Ask Experts

Volunteer

Rob Painter

Expertise

Alarm system questions cannot be answered on this forum. These systems are not what I can answer. Without being physically at the vehicle and not knowing what kind of electrical service has been done on the vehicle, there is no possible way to give an accurate answer over the internet. My expertise is in Ignition/key based anti-theft systems. These issues include GM VATS (resistor chip in key blade) PASSLOCK (MRD)-ignition lock rotation based, no special ignition key and the PKIII Transponder (computer chip in key) systems. These systems are not alarm based and are integral with the starting of the engine. This is why I cannot diagnose alarm problems without physically looking at the vehicle: Alarm systems are a completely different annimal than ignition key/lock based anti-theft system. Many alarm questions come from vehicles 10 years old, and since older, many hands that had been involved over the years.I am an expert in all GM factory (ignition/key based)systems. Alarm system questions pose to many situations beyond my knowledge as to what has been done to the vehicle over the years. Some guy may have actually wired the stereo into the alarm system. Who knows? Over my past 30 years in vehicle wiring repair, I have seen unbelievable wiring disaters done by guys that consider themselves "mechanics." I have seen stereos and alarms intalled using surgical tape. I have seen modules burn up, un-fused circuits, wiring jambed between the doors and even lamp cord used for a starter kill. To answer alarm questions over the internet without examining the vehicle is like asking; What does it take to remove a dent?

Experience

Education/Credentials-ASE certified. 11 years with a GM dealer and 17 years with a repair facility dealing with only the repair of theft recovered vehicles.

©2012 About.com, a part of The New York Times Company. All rights reserved.