Cadillac Repair/Power Cable

Advertisement


Question
how to hook up power cable from amps through the car to the battery in a cadillac seville 1994

Answer
Hi Jake,

Don't do it like the crap installs I have seen by running the power cord in between the door.

Find a good location in the fire wall between the engine area and the passenger compartment.

Go to radio shack or somewhere like it. Get a rubber grommit that will incorporate your wiring through it. Drill a hole. Deburr. Install your grommit. Run the wire therough. Make sure you have the appropriate in line fuse before hooking to battery. Install to amp and stereo.

Rob

Cadillac Repair

All Answers


Answers by Expert:


Ask Experts

Volunteer


Rob Painter

Expertise

Alarm system questions cannot be answered on this forum. These systems are not what I can answer. Without being physically at the vehicle and not knowing what kind of electrical service has been done on the vehicle, there is no possible way to give an accurate answer over the internet. My expertise is in Ignition/key based anti-theft systems. These issues include GM VATS (resistor chip in key blade) PASSLOCK (MRD)-ignition lock rotation based, no special ignition key and the PKIII Transponder (computer chip in key) systems. These systems are not alarm based and are integral with the starting of the engine. This is why I cannot diagnose alarm problems without physically looking at the vehicle: Alarm systems are a completely different annimal than ignition key/lock based anti-theft system. Many alarm questions come from vehicles 10 years old, and since older, many hands that had been involved over the years.I am an expert in all GM factory (ignition/key based)systems. Alarm system questions pose to many situations beyond my knowledge as to what has been done to the vehicle over the years. Some guy may have actually wired the stereo into the alarm system. Who knows? Over my past 30 years in vehicle wiring repair, I have seen unbelievable wiring disaters done by guys that consider themselves "mechanics." I have seen stereos and alarms intalled using surgical tape. I have seen modules burn up, un-fused circuits, wiring jambed between the doors and even lamp cord used for a starter kill. To answer alarm questions over the internet without examining the vehicle is like asking; What does it take to remove a dent?

Experience

Education/Credentials-ASE certified. 11 years with a GM dealer and 17 years with a repair facility dealing with only the repair of theft recovered vehicles.

©2012 About.com, a part of The New York Times Company. All rights reserved.