You are here:

Cadillac Repair/92 Deville ABS light on

Advertisement


Question
Thanks again for service you are providing the community,I for one,am proof of the value of your volunteer work.You saved my father the time and cost of dealer repair of pass key problem.ABS light on, is there any other way of retrieving codes without scan  tool,and what are some of the most common causes of ABS light on?...Thanks,    Ray.

Answer
Hi Ray,

There are many reasons the ABS light can be on for. Could be a sensor, the computer and other things tied in.

You will need to scan for codes and find out what the codes mean. If you are going to keep the car, I would suggest getting a service manual from Ebay or Helm.

As far as scanning, you can buy the scanners pretty cheap at about any parts store these days.

Good Luck!

Rob

Cadillac Repair

All Answers


Answers by Expert:


Ask Experts

Volunteer


Rob Painter

Expertise

Alarm system questions cannot be answered on this forum. These systems are not what I can answer. Without being physically at the vehicle and not knowing what kind of electrical service has been done on the vehicle, there is no possible way to give an accurate answer over the internet. My expertise is in Ignition/key based anti-theft systems. These issues include GM VATS (resistor chip in key blade) PASSLOCK (MRD)-ignition lock rotation based, no special ignition key and the PKIII Transponder (computer chip in key) systems. These systems are not alarm based and are integral with the starting of the engine. This is why I cannot diagnose alarm problems without physically looking at the vehicle: Alarm systems are a completely different annimal than ignition key/lock based anti-theft system. Many alarm questions come from vehicles 10 years old, and since older, many hands that had been involved over the years.I am an expert in all GM factory (ignition/key based)systems. Alarm system questions pose to many situations beyond my knowledge as to what has been done to the vehicle over the years. Some guy may have actually wired the stereo into the alarm system. Who knows? Over my past 30 years in vehicle wiring repair, I have seen unbelievable wiring disaters done by guys that consider themselves "mechanics." I have seen stereos and alarms intalled using surgical tape. I have seen modules burn up, un-fused circuits, wiring jambed between the doors and even lamp cord used for a starter kill. To answer alarm questions over the internet without examining the vehicle is like asking; What does it take to remove a dent?

Experience

Education/Credentials-ASE certified. 11 years with a GM dealer and 17 years with a repair facility dealing with only the repair of theft recovered vehicles.

©2012 About.com, a part of The New York Times Company. All rights reserved.