Cadillac Repair/radio

Advertisement


Question
Recently had front floor repaired on 96 Fleetwood brougham and now radio does not work. Radio is on but no sound and antenna does not go up.

Answer
Hello,

The problem here is that there is no way of knowing what was inadvertantly cut that would cause this situation.

You have more than one fuse box in the car. Consult you owners manual for locations.

Check the fuses first. If you get power to the stereo, power should come from it to raise and lower the antenna. This means you may have only one problem. The stereo is operated off of switched power.

If you get the stereo working and the presets don't stay, that is another fused circuit which is on constant power.

Might be a simple fix just by changing a fuse.

Http://www.autotheftexpert.org

Cadillac Repair

All Answers


Answers by Expert:


Ask Experts

Volunteer


Rob Painter

Expertise

Alarm system questions cannot be answered on this forum. These systems are not what I can answer. Without being physically at the vehicle and not knowing what kind of electrical service has been done on the vehicle, there is no possible way to give an accurate answer over the internet. My expertise is in Ignition/key based anti-theft systems. These issues include GM VATS (resistor chip in key blade) PASSLOCK (MRD)-ignition lock rotation based, no special ignition key and the PKIII Transponder (computer chip in key) systems. These systems are not alarm based and are integral with the starting of the engine. This is why I cannot diagnose alarm problems without physically looking at the vehicle: Alarm systems are a completely different annimal than ignition key/lock based anti-theft system. Many alarm questions come from vehicles 10 years old, and since older, many hands that had been involved over the years.I am an expert in all GM factory (ignition/key based)systems. Alarm system questions pose to many situations beyond my knowledge as to what has been done to the vehicle over the years. Some guy may have actually wired the stereo into the alarm system. Who knows? Over my past 30 years in vehicle wiring repair, I have seen unbelievable wiring disaters done by guys that consider themselves "mechanics." I have seen stereos and alarms intalled using surgical tape. I have seen modules burn up, un-fused circuits, wiring jambed between the doors and even lamp cord used for a starter kill. To answer alarm questions over the internet without examining the vehicle is like asking; What does it take to remove a dent?

Experience

Education/Credentials-ASE certified. 11 years with a GM dealer and 17 years with a repair facility dealing with only the repair of theft recovered vehicles.

©2012 About.com, a part of The New York Times Company. All rights reserved.