You are here:

Cadillac Repair/traction control

Advertisement

Expert: - 1/14/2012


Question
how can i ENABLE traction control on my 1994 Cadillac Seville? it's been disabled manually. i need it back on.any help would be greatly appreciated.
         Kevin

Answer
Hello,

You say it's disabled manually, however since there is no standard to enable it. You should have a traction control switch on the console. It's possible, that someone pulled out the switch and disconnected it. It may be as simple as removing the switch and reconnecting the connector. Other than that, I do not know how the traction control was disabled.

http://www.autotheftexpert.com

Cadillac Repair

All Answers

Answers by Expert:

Ask Experts

Volunteer

Rob Painter

Expertise

Alarm system questions cannot be answered on this forum. These systems are not what I can answer. Without being physically at the vehicle and not knowing what kind of electrical service has been done on the vehicle, there is no possible way to give an accurate answer over the internet. My expertise is in Ignition/key based anti-theft systems. These issues include GM VATS (resistor chip in key blade) PASSLOCK (MRD)-ignition lock rotation based, no special ignition key and the PKIII Transponder (computer chip in key) systems. These systems are not alarm based and are integral with the starting of the engine. This is why I cannot diagnose alarm problems without physically looking at the vehicle: Alarm systems are a completely different annimal than ignition key/lock based anti-theft system. Many alarm questions come from vehicles 10 years old, and since older, many hands that had been involved over the years.I am an expert in all GM factory (ignition/key based)systems. Alarm system questions pose to many situations beyond my knowledge as to what has been done to the vehicle over the years. Some guy may have actually wired the stereo into the alarm system. Who knows? Over my past 30 years in vehicle wiring repair, I have seen unbelievable wiring disaters done by guys that consider themselves "mechanics." I have seen stereos and alarms intalled using surgical tape. I have seen modules burn up, un-fused circuits, wiring jambed between the doors and even lamp cord used for a starter kill. To answer alarm questions over the internet without examining the vehicle is like asking; What does it take to remove a dent?

Experience

Education/Credentials-ASE certified. 11 years with a GM dealer and 17 years with a repair facility dealing with only the repair of theft recovered vehicles.

©2012 About.com, a part of The New York Times Company. All rights reserved.