| |
You are here: Experts > Autos > Auto Parts > Car Alarms > pursuit car alarm
Expert: ALARMTEK - 11/9/2009
Question
QUESTION: 98 honda accord came with pursuit car alarm-lost only alarm remote, toggle switch that was on floor is gone( only white & grey wire is hanging) -the car is stuck in a parking lot -how do i start it - desperate
ANSWER: Ok then, get over to the local car alarm shop,
or Best Buys will have a valet switch that
will fit for your
alarm.
In the mean time twist those 2
free hanging wires together, turn on the ignition,
hold both wires to ground until the siren chirps.
That should reset and place the alarm into
over ride for now. Nothing accept the keyless entry
if installed will operate until you repeat the
same steps.
Then get a new switch and you're all set.
Have a good day.
Let me know if you were
successful.
ALARMTEK
CARALARMZ.COM
---------- FOLLOW-UP ----------
QUESTION: i tried doing the twist wires together ,turning on ignition & grounding wires -nothing happened . -1 - how hard is it too just disconnect the whole thing, can it be done with basic tools in a parking lot.
-2 will the valet switch work.- im trying to find the cheapest way - really desperate
thanx
Answer
Procedure.
KEY ON, TAKE THE 2 TWISTED VALET SWITCH WIRES
AND THEN WITHIN 10 SECONDS PRESS TO METAL ON FRAME
AND HOLD TO GROUND FOR UP TO 6 SECONDS OR
UNTIL ALARM RESPONDS.
KEY OFF="VALET OVERRIDE".
was this what you did? If not try again.
Removal and repair will require some tools
and notes: www.WIREWERX.com
A.
Ask a Question
|
|
