You are here:

Car Alarms/Nissan 1999 Quest anti theft

Advertisement

Expert: - 7/14/2010


Question
My car alarm (factory)goes off and I cannot start the van. My remote only locks the car. I have been using manual keys for the past 12 months. Please help

Answer

VALET
Ok, follow me on this...
 This system depends on the physical action
of the door lock locking and unlocking-arming and disarming.
If you have a factory remote, that would do this to
specifications.

This can only be achieved 3 ways:

1. Use key in the drivers door, turn left,
then right to disarm and unlock.

2. Add an after market keyless entry system to emulate
the factory remote functions. I have several models
if this option suits you.

3. Acquire or use & or, replace the original remote that
can control it as specified. This would be at the
local dealership parts department.

(This is why there is no wire you could ground
without affecting the door lock system.
A single negative pulse to the unlock wire will disarm
without unlocking, yes, but would always disable the
locking mechanism. Not good.)

Keep in mind, if this is after market
(siren and flashing parking lights)
then it's a different method entirely.

The standard method to disables as follows:

Look under the dash area for a button or, a toggle
switch. When you locate it, turn on the ignition
key, press and hold in the button (little
spring loaded micro button, red or black possibly)
until the alarm chirps 1 time. This should over ride
the system, and only the keyless entry part,
if installed, would still be operating.
The LED (light emitting diode) light in the dash
should also go on solid. If it's a toggle type,
then key on, flip the switch in the other direction
This would be OVERRIDE/VALET mode.

Repeat this process to toggle back to service mode.

Lastly this car has a transponder in the ignition key
and ignition column. if this system is in "TAMPER MODE"
and the fuel rail has shut down, there is nothing
you can do personally to disable it. The dealer will need
to put it into a diagnostic reset through they're
code reader writer system in the service dept.


Let me know what applies
to your issues.

R. Martin - ALARMTEK
    Questioner's Rating
    Rating(1-10)Knowledgeability = 10Clarity of Response = 10Politeness = 10
    CommentThank you. After 25 minutes of lights and horn, I managed to quiet this with the key method of back to the right and forward to the left. Thank you again.


  • Ask a Question

Car Alarms

All Answers

Answers by Expert:

Ask Experts

Volunteer

ALARMTEK

Expertise

Expertise: Questions about installing/using car alarms, auto starts, and other car security devices. I am the owner of ALARMTEK AUTO SECURITY and have been on the internet since 1994, providing online installation tech support for professional and backyard installers.

Experience

Certification & Qualifications: 28 YEARS IN THE SAME LOCATION INSTALLING CAR ALARMS & ACCESSORIES. 4 YEARS AT DESIGNTECH INTERNATIONAL TECH SUPPORT DESK - NOKIA TECH COURSE-AAMP & BISHOP ELECTRONIC CERTIFICATES, SKY TRACK 12 VOLT GLOBAL POSITIONING-PRODUCT INSTALLATION-APPLICATION/MASTER CERTIFICATION COURSE & MORE!

Thank You For Stopping By!
VISIT MY REMOTE STARTER PAGE
VISIT MY GM PASSLOCK SITE!
!!PLEASE READ THIS NOTE!!
I do not provide remote transmitter
programming here!
WE OFFER NO DEI/VIPER SUPPORT HERE AT ALL!
PLEASE GO TO INSTALLSUPPORT.COM
CLICK HERE TO PURCHASE REPLACEMENT REMOTES!



Education/Credentials
SCHOOLS & GRADUATED PROGRAMS INCLUDE: CELLULAR ONE QUALITY CONTROL-BELL ATLANTIC MOBILE-IMTL- SILVER LEVEL MECP-HONDA/TOYOTA SECURITY APPLICATION SPECIALIST. PASSLOCK BYPASS SPECIALIST.

©2012 About.com, a part of The New York Times Company. All rights reserved.