Expert: ALARMTEK - 1/30/2011

Question
Ok, here i go! I purchased a 2008 ram pickup with auto trans and a gs-2260tw-fm remote starter with a nahrlcd4 remote fob that came with the truck. I damaged the fob beyond repair, (ran it over with forklift)the only fob that came with the purchase of truck and now have replaced it with a used one (same fcc id)over the internet.  I have noticed the blue blinking light no longer flashes on the top of windshield where the antenna is installed.  How do i now program the new fob to the brain of the starter? I will be receiving the recently purchased fob Jan 31, 2011 and would like to be prepared with instructions.  Please and thank-you.  Regards, Mario

Answer
If you did not notice, there is a note on
the site you just submitted this question from
that says I do not provide remote transmitter
programming information here.

That's still true.
I just don't offer that assistance.
 
Try a site like www.keylessride.com.
www.keynfob.com , or www.remotes4you.com
as providing replacement remote transmitters
and programming them, is what they specialize in.

Sorry about that.
Good luck with it.

R. Martin/ALARMTEK
CARPROTECTOR.com