Expert: ALARMTEK - 12/20/2011

Question
Hi Folks.  I'm stumped.  I've installed a remote start and transponder bypass in my wifes van and everything works - almost.  On a remote start, the VSC light and airbag light remain on.  I used ingition black wire as ignition and ignition black/yellow as ignition 2, ignition pink for accessory but can't locate the circuit to power up to turn off these warning lights and still power the accessory circuit for the heater control. Am I missing an accessory 2 circuit ?
Any suggestions will be truly appreciated !

Answer
Check in the feature setting for a dual purpose wire. It may be default as
one thing, but the manual may also allow for a 3rd ignition/ACC
to be programmed.

But here's the thing,
You are on the correct wiring:

WIRE  COLOR  POLARITY  LOCATION
  
Battery  WHITE/RED  (+)  IGNITION SWITCH HARNESS   
Ignition 1  BLACK  (+)  IGNITION SWITCH HARNESS   
Ignition 2  BLACK/YELLOW  (+)  IGNITION SWITCH HARNESS   
Accessory 1  PINK  (+)  IGNITION SWITCH HARNESS   
Starter 1  BLACK/YELLOW  (+)  IGNITION SWITCH HARNESS   
Anti-Theft Type  UNIVERSAL IMMOBILIZER   
Anti-Theft Descript  THE KEY SENDS AN RF SIGNAL TO THE
BCM MODULE THROUGH AN ANTENNA LOCATED AROUND THE IGNITION CYLINDER   
Key Sense  BLUE/BLACK  (-)  IGNITION SWITCH HARNESS   
Tachometer  GREEN/RED  (AC)  AT ECM MODULE TO RIGHT OF GLOVEBOX   
Speed Sense  VIOLET/WHITE  (AC)  AT ECM MODULE TO RIGHT OF GLOVEBOX   
Parking Lights  GREEN/BLACK  (-)  IGNITION SWITCH HARNESS   
Brake Lights  GREEN/WHITE  (+)  AT SWITCH ABOVE BRAKE PEDAL   
Reverse Lights  RED/BLACK  (+)  IN HARNESS IN DRIVER KICKPANEL   
Horn  GREEN/BLACK  (+)  IGNITION SWITCH HARNESS

Are you using a tach wire or tachless?
What bypass kit are you attempting to use?




ALARMTEK