Expert: ALARMTEK - 4/20/2011

Question
I have a gm after market alarm install on the 2003 Chev S10. The remote work and the relay work fine for opening and closing the doors.  The only problem that I am having is that led indicator light always on when alarm instead of flashing.  Any suggestion?

THanks  


Steve

Answer
Should be no problem really.
It appears from your expaination, that the
after market car alarm is in service mode.

Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area, usually to the
left of the leg drilled into a hidden away spot,
until the installed LED (the blinking light)
in your dash area goes off, and the siren chirps twice.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in oposite direction,
key off.)

This should reset the alarm.

Just Repeat these steps to place it
back to valet mode.

Good luck with it.

ALARMTEK