You are here:

Car Alarms/Prestiage alram

Advertisement


Question
alarm is in NON ALARM MODE and i would like to change it back,but I can not find the valet switch for it. help me please. model#aps2k4sbcf

Answer
Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, locate, press and hold in the
valet/overide button, found under the
dash area, (push button, spring loaded)
until the installed LED (the blinking light)
in your dash area goes on solid,
and the siren chirps once.

(Your valet switch might be the toggle
(on/off) type. in this case, key on,
flip switch in opposite direction,
then turn the key off.)

This should reset the alarm, and reset
the grounded relay on the starter wire,
allowing you to start the engine.

At this point, the only thing working would
be the keyless entry from the alarm,
if it came equipped that way.

Just Repeat these steps to place it
back to usable armed mode.
You may get 2 chirps, confirming it,
and the lights may flash twice as well.

That should do it.
If you want to remove it at this point,
take it to your neighborhood installer
for this, or buy the wiring chart
(Go to: www.vehiclewires.com)
for the vehicle, and reverse engineer it wire
by wire, until safely removed.

If it does not work out this way,
you will have to replace the system
with one you know how to operate
and what to expect. Don't want to
get stuck in another bad situation.

Let me know what happens.

Robert Martin/CEO-ALARMTEK

Car Alarms

All Answers


Answers by Expert:


Ask Experts

Volunteer


ALARMTEK

Expertise

Expertise: Questions about installing/using car alarms, auto starts, and other car security devices. I am the owner of ALARMTEK AUTO SECURITY and have been on the internet since 1994, providing online installation tech support for professional and backyard installers.

Experience

Certification & Qualifications: 42 YEARS IN THE SAME LOCATION INSTALLING CAR ALARMS & ACCESSORIES. 4 YEARS AT DESIGNTECH INTERNATIONAL TECH SUPPORT DESK - NOKIA TECH COURSE-AAMP & BISHOP ELECTRONIC CERTIFICATES, SKY TRACK 12 VOLT GLOBAL POSITIONING-PRODUCT INSTALLATION-APPLICATION/MASTER CERTIFICATION COURSE & MORE!

Thank You For Stopping By!
VISIT MY GPS TRACK AND KILL PAGE
!!PLEASE READ THIS NOTE!!
I do not provide remote transmitter
programming here!

WE OFFER NO DEI/VIPER SUPPORT HERE AT ALL!



Education/Credentials
SCHOOLS & GRADUATED PROGRAMS INCLUDE: CELLULAR ONE QUALITY CONTROL-BELL ATLANTIC MOBILE-IMTL- SILVER LEVEL MECP-HONDA/TOYOTA SECURITY APPLICATION SPECIALIST. PASSLOCK BYPASS SPECIALIST.

©2016 About.com. All rights reserved.