You are here:
Chimney & Fireplaces/flue size
Advertisement
Question
what is the minimum flue size available for a wood burning fireplace?
We have interior dimensions of approximately 12 inches to the studs and are being told we can't install a wood burning fireplace flue in that space.
Libby,
A factory built fireplace, like one you would purchase complete with firebox, chimney and cap, would have specific limitation on clearances. Most that comes to mind have a 12" inch outer pipe that would require a one or two inch clearance on top of that. If masonry construction is is your question, the odds are even worse. I would heed the advice of you local professional. Best of luck to you.
- Add to this Answer
- Ask a Question
| Rating(1-10) | Knowledgeability = 10 | Clarity of Response = 10 | Politeness = 10 |
| Comment | Thank you - you saved me tons of time researching! | ||
Related Articles
- Materials Needed To Make a Scale Miniature Fireplace or Fireplace Mantel
- Easy Home Winterizing Checklist - Wood Burning Fireplace / Chimney / Flue
- Make a Scale Miniature Fire Place from Wood or Recycled Basic Furniture - Make a Dolls House Fireplace
- Fireplaces for Home | Determining Best Wood Burning Units
- Picture of Oil Burning on Top of the Water at Pearl Harbor
Answers by Expert:
Randy Brooks
Expertise
Inspection of Masonry, Pre-cast Tilt-up, and Factory Built Fireplaces as well as Free Standing & Insert, Gas, and Wood Appliances. We also provide Hearth Fire Loss Investigations, Litigation Support, Consulting Services, Flue Sweeping, Installation and Repair. Additionally, I’ve been a chimney sweep for 23 years, service and install hearth appliances as well as being recognized by the Superior Court of California as an expert witness.
Experience
Brooks Chimney Sweeping Since 1989
Ojai, CA
Owner / President www.brooks-hearth.com
Organizations
NCSG, MEMBER,(National Chimney Sweep Guild), Member since 1990, Board of Directors representing Region 6, (CA, NV, AZ, UT, OR, WA, ID, WY, MT, AK and HI,) 2004-2011, ethics committee chair, 2004-2005, executive committee member, Vice President, 2006-2008, President, 2008-2011.
CSIA, BOD (Chimney Safety Institute of America,) Board of Directors, ethics committee chair, 2004-2005, executive committee member, Secretary, 2005-2006, Vice President, 2006-2008, President, 2008-2011.
HPBA, MEMBER, (Hearth, Patio, & BBQ Association,) since 2002.
NFPA Member, (National Fire Protection Association) Since 2009. Technical Committee member for the 211 Standard.
Education/Credentials
California State Licensed Contractor, C61-D34, #750710.
http://www2.cslb.ca.gov
C.S.I.A., (Chimney Safety Institute of America,) Certified Chimney Sweep, #2580. Held since 1990 re-certified in ‘93, ‘96, ‘99, ‘02, ‘05, '08,'11.
http://www.csia.org
F.I.R.E. (Fireplace Investigation, Research & Education Service,) Certified Inspector, #FP-006. Held since 2000, re-certified in ’03, ‘06.
http://www.f-i-r-e-service.com
Fireplace Investigation, Research & Education Service,) Advance Expert Consulting & Witness, certificate, ’05
N.F.I. (National Fireplace Institute,) Certified Gas & Wood-Burning Specialist, #133851. Held since 2002, re-certified in '05,‘08.
http://nficertified.org
©2012 About.com, a part of The New York Times Company. All rights reserved.