You are here:

Chimney & Fireplaces/Deteriorated Chimney options

Advertisement


Question

Chimney
Attached are a few pictures of a chimney needing repair.  The house has no fireplaces and the chimney is used only for appliance venting.  We are planning on relining, but upon further inspection we found that the masonry above the roofline is shot.  My plan is to remove the masonry to just above the roofline, add a liner, install a 3' prefab pipe w/cap to meet code height, and finally add a mortar cap around the new pipe at the top of the existing chimney. Does this sound ok? Or would I be better off rebuilding the existing masonry and then adding a cap? Also how do I know what size pipe to reline with?

Answer
Hi Scott,

You should be able to tear the chimney down below the roofline, add the liner and the 3' b-vent, re-deck, re-roof and re-flash.

You'll have to consult the NFPA 54 tables to determine the size of liner you need.  That is dependent on many factors including btu input, length of run, connector type and size, etc...

Thanks for using AllExperts.Com and good luck with your project.

Sincerely,
A. Bart Ogden, President
Home Safe Hearth & Chimney, Inc.
Wichita, KS
Voice 316-265-9828
Fax 316-265-9890
www.HomeSafeKS.com

CSIA Certified Chimney Sweep #2653
CSIA Certified Dryer Exhaust Technician #10
NFI Certified Wood Specialist
NFI Certified Gas Specialist
NFI Certified Pellet Specialist
NFI Master Hearth Professional
NCSG Technical Advisory Council Member

Bart Ogden

Expertise

I can answer questions related to chimney and fireplace cleaning, construction and repair as well as questions related to the performance of chimneys and fireplaces. I can also answer questions related to clothes dryer vent cleaning and repair. Additionally, I can field questions related to masonry repair.

Experience


Experience in the area:
28 years experience in the chimney service/installation/repair field
President, Home Safe Hearth & Chimney, Inc. Wichita, Kansas

Professional Organizations:
Member, National Chimney Sweep Guild (NCSG)
Member, Hearth, Patio & Barbecue Association (HPBA)
Member, Kansas Guild of Professional Chimney Sweeps (KGPCS)
Member, Midwest Chimney Safety Council (MCSC)
Member, Kansas Association of Real Estate Inspectors (KAREI)
Past At-Large Director of the National Chimney Sweep Guild
Past At-Large Director of the Chimney Safety Institute of America
Past Secretary, National Chimney Sweep Guild
Past Secretary, Chimney Safety Institute of America
Member, National Chimney Sweep Guild Technical Advisory Council
Member, Chimney Safety Institute of America Certification Committee
Past Chairman, CSIA Chimney Safety Education Brochures Committee
Past Chairman, NCSG Nomination Committee

Publications:
SWEEPING Magazine, The Journal of Chimney & Venting Technoloty, A Publication of the National Chimney Sweep Guild
SNEWS, The Chimney Sweep News
THE KANSAS SWEEP, The Voice of the KS Guild of Professional Chimney Sweeps

Education/Credentials:
BA, Wichita State University
C.S.I.A. Certified Chimney Sweep
C.S.I.A. Certified Dryer Exhaust Technician
N.F.I. Woodburning Specialist
N.F.I. Gas Specialist
Chimney Diagnosis & Documentation Seminar
Ahren's Masonry Restoration School Graduate
Advanced Gas Certification
Master Gas Certification
Licensed Mechanical Contractor
Pellet Appliance Specialist
Venting Design Specialist
Dale Carnegie Course Graduate

Awards and Honors:
Superior Dealer Award, Ventinox Chimney Lining Systems

©2012 About.com, a part of The New York Times Company. All rights reserved.