AllExperts > Experts 
Search      

Chrysler Repair

Volunteer
Answers to thousands of questions
 Home · More Questions · Question Library  · Free Encyclopedia ·
More Chrysler Repair Answers
Question Library

Ask a question about Chrysler Repair
Volunteer
Experts of the Month
Expert Login

Awards

About Us
Tell friends
Link to Us
Disclaimer

 
 
 
About Roland Finston
(Top Expert on this page)

Expertise
I take questions about domestic Chrysler-product front wheel drive cars and minivans for the years 1982-2000 based upon my experience and shop manuals. I don't have detailed information (e.g. manuals) nor expertise for Jeeps, trucks, SUV's, import vehicles, or for years more recent than 2000 (except Sebring/Stratus I have '03). I am available to take a question between 8AM CT and 9PM CT, and attempt to provide an answer within 1 hour. If I am shown as "maxed out" try again later in the day as I add question opportunities one at a time so as to respond quickly, but I do have other responsibilities as well so may not be available for several hours at times. Try at 7PM CT as I will always be available for one question then. There are answers to hundreds of Chrysler questions at your finger tips: click on "view past answers", one of which may be to your question as well; or put a few key words in the "search for" box, above.

Experience
I have been a do-it-yourself auto hobbyist for 5 decades, and most recently have been concentrating on the various Chrysler Corporation domestic front wheel drive cars and vans. I have shop manuals and wiring diagrams for many models for the years '83-'00, as well as rear wheel drive cars for the early 80's. I enjoy analyzing problems that other Chrysler enthusiasts are having and sharing my information.

Organizations belong to
Group co-moderator of the Yahoo autos group The Chrysler LeBaron Club

   

You are here:  Experts > Home/Garden > Auto Repair > Chrysler Repair

SubjectDate AskedExpert

Engine loses power above 35 mph, code 219/5/2008Roland Finston
  Q: My husband owns a 1992 Chrysler Lebaron Sedan. He has been having problems with it lately. It ...
  A: As far as I can tell if the readouts both came from the diagnostic connection under the hood (which ...
2003 Transmission won't power the car9/5/2008Roland Finston
  Q: My car was going down the road and then just lost every gear with no warning. The fluid is fine. it ...
  A: If you have the V-6 engine then you have an "electronic" transmission. That means there is a ...
Location of the Valve Body9/4/2008Roland Finston
  Q: My husband owns a 1992 Chrysler Lebaron Sedan. He has been having problems with it lately. It ...
  A: There is an inconsistency in what you were told, and because you didn't mention which ...
'97 3.0L stumbles on warm restart9/4/2008Roland Finston
  Q: I have a 97 Voyager 3.0 that has a stumble only after a warm restart of the engine. When you drop ...
  A: Because the only temp sensitive sensor is the coolant temp sensor, that would be one item to check ...
Brake warning light flashes occasionally9/4/2008Roland Finston
  Q: I have a 1998 Dodge Caravan. The "BRAKE" dash light has started to come on at times. Brakes seem to ...
  A: The brake light is indicative of either an imbalance in the brake line hydraulic pressure between ...
Instrument Panel lights not working.9/4/2008Roland Finston
  Q: Our 1998 Chrysler T/C 3.8L LXi stopped running. Towed it to dealer and had to replace the PCM. ...
  A: My working theory is that it is the cluster itself that is at fault, which cannot be easily ...
power door lock motor replacement: van9/4/2008Roland Finston
  Q: the power lock on my wife's '01 T&C Ltd has started wearing out. When she uses the keyless remote to ...
  A: I'm working with a '98 manual, which I assume applies to your '01 model. It appears that the power ...
1994 Chrysler T&C 3.8L Code 439/4/2008Roland Finston
  Q: Check engine light came on while driving and I noticed an odd smell like burning plastic/rubber. ...
  A: The 43 code means that one of the three separate spark coils in the coil pack is not responding ...
1984 Chrysler T&C mech. fuel pump9/3/2008Roland Finston
  Q: Roland - My brother has removed fuel pumps before but is trying to replace the mechanical fuel pump ...
  A: The '84 manual show the fuel pump just has a long rocker arm that extends into the engine, with a ...
1998 Neon has started running roughly.9/3/2008Roland Finston
  Q: I recently purchased a 1998 Dodge Neon Highliner Coupe. Within the last few days, it has begun ...
  A: About the only possibilities for 'Link Error' would be either the ignition switch was not turned on ...
'99 T&C starts/dies after a few seconds: etax relay?9/3/2008Roland Finston
  Q: Our Chrysler Town and Country will sometimes not start. In that it will starts for a few seconds ...
  A: That relay is what powers the solenoid hydrualic switching box on the side of the transmission. If ...
2.7 intrepid engine timing chains installation9/3/2008Roland Finston
  Q: timing chain issues.i line up secondary sprocket dots straight up inline with cams then the primary ...
  A: I am unclear about what aspect you are speaking about. However, the timing of the secondary chains ...
1998 Neon has started running roughly.9/3/2008Roland Finston
  Q: I recently purchased a 1998 Dodge Neon Highliner Coupe. Within the last few days, it has begun ...
  A: I would get a fault code readout of the engine controller to see if the engine controller has ...
Town&Country headlights blinking?9/2/2008Roland Finston
  Q: My wife's 2001 van wouldn't start after work tonight. At some point during the day while she was at ...
  A: I suspect that this is a malfunction of the theft security system which is initiated from the body ...
'95 LHS Transmission: shift problem/codes9/2/2008Roland Finston
  Q: Our 95 LHS (134K miles) will no longer shift into overdrive and after driving for about one hour ...
  A: Have you ever replaced the fluid in the trans? A power flush and thus total fluid replacement might ...
Instrument Panel lights not working.9/2/2008Roland Finston
  Q: Our 1998 Chrysler T/C 3.8L LXi stopped running. Towed it to dealer and had to replace the PCM. ...
  A: The panel lights are mediated through the body computer, not the pcm. But before going any further I ...
1999 town & country: won't start, etax relay clicks9/2/2008Roland Finston
  Q: eatx shutdown relay making clicking noise engine spins over but won't crank also just died while ...
  A: I am unclear about 'spins over' as compared to 'won't crank' because I associate cranking with ...
2.5 V-6 trans won't move the car: codes 36, 44, 549/2/2008Roland Finston
  Q: Limp mode had occured once or twice before getting to the highway, restarted the car and had taken ...
  A: There are two issues that appear to be independent, which along with the metal parts in the pan, ...
Plymouth Breeze Horn9/2/2008Roland Finston
  Q: I have a 96 Plymouth Breeze. The horn will not stop. I had to remove the relay to silence it. Any ...
  A: Either the relay is stuck in the "on" position, or the grounding wire that activates the relay is ...
1997 Chrysler LHS good battery, no electrical9/2/2008Roland Finston
  Q: I put a new battery in my LHS. Battery works in another car. I have no power to anything, no curtesy ...
  A: You would want to check the following: The battery terminals and the inside surfaces of the cable ...
rear window repair on 2002 Sebring9/2/2008Roland Finston
  Q: My brother in law took my door panel off in an attempt to get my window up since the motor stopped ...
  A: I have a manual for the 2003 which is similar (though not identical) to the 1998 manual I also have, ...
wrong timing marks?: 2.5 V-69/2/2008Roland Finston
  Q: I replaced water pump and timing belt on 1995 Cirrus LXI 2.5 but ever since I can't get it to run ...
  A: I believe that you are looking at manual figure for the 2.4L engine, not the 2.5; only the 2.5 has a ...
downshift transmission issue9/1/2008Roland Finston
  Q: As Thomas stated, my 2000 Chrysler Sebring transmission also bucks when the car is decelerating ...
  A: Have they done a fault code readout to see if the transmission computer has noted any explanations ...
2.5 V-6 trans won't move the car9/1/2008Roland Finston
  Q: Limp mode had occured once or twice before getting to the highway, restarted the car and had taken ...
  A: I would try to get the fault code readout on the transmission memory which is likely to be available ...
1998 300M engine stall problem8/31/2008Roland Finston
  Q: I have read several articles about 300M stalling. My car i had a similar problem where my engine all ...
  A: If the engine starts, runs for some number of minutes, then loses power and finally dies and won't ...
Chrysler 300 not starting8/30/2008Roland Finston
  Q: 2005 300 chrysler will not crank but everything powers up.
  A: By "will not crank" I assume that you mean the starter motor will not turn the engine over, correct? ...
1998 Town & Country:Ignition Key will not turn8/30/2008Roland Finston
  Q: I went to start my 98 T&C, The key will not turn in either direction, the steering wheel is not ...
  A: You didn't mention whether when you put it in Park whether it would or wouldn't move in either ...
Starter clicks rapidly8/30/2008Roland Finston
  Q: Saw an eariler question about rapid oscillations when trying to start a Chrysler mini-van. I have a ...
  A: There are 4 different engines that you might have so I can't be sure. But in general the starter is ...
03 T & C a/c control: blower only runs high8/30/2008Roland Finston
  Q: my front a/c with duel zone and climate control, the blower motor only blows on high.can not cut ...
  A: When the blower only runs on high, that is a sign that the blower motor resistor block has gone bad. ...
3.0L V-6 overheating8/30/2008Roland Finston
  Q: car only will run fan when it's at the point of over heating then it runs long anough to bring temp ...
  A: That behavior would suggest that either the temperature gauge/sender on the dash is inaccurate or ...
I need to take off my 99 300m passenger fender.8/30/2008Roland Finston
  Q: I need some directions on how to remove the fender and wheel well. Thanks for your help!
  A: The basic steps are: remove headlamp housing remove front bumper facia as necessary to clear path ...
'99 T&C starts/dies after a few seconds: theft alarm8/30/2008Roland Finston
  Q: Our Chrysler Town and Country will sometimes not start. In that it will starts for a few seconds ...
  A: That certainly sounds like the theft alarm being in the false alarmed state. You can try to ...
'94 electrronic transmission problem: code 28 and 448/29/2008Roland Finston
  Q: I have a Chrysler Concorde 1994 3.3l, I have a transmission problem, the PRN@3L lights is on in ...
  A: Your battery may be weak, but typically once the engine is running the alternator will put out ...
2002 Chrysler Sebring: code 03408/29/2008Roland Finston
  Q: Roland, Thanks for taking time to help me. Two days ago I went to get my old changed. When they ...
  A: You didn't mention which engine is in the vehicle so I can't comment on whether the shop could have ...
'94 electrronic transmission problem: code 28 and 448/28/2008Roland Finston
  Q: I have a Chrysler Concorde 1994 3.3l, I have a transmission problem, the PRN@3L lights is on in ...
  A: It is good that you have a mechanic with a scan tool. Is it the Chrysler DRB II tool? On the 28 it ...
1990 2.5L 4 cyl. no start8/28/2008Roland Finston
  Q: I know this is long please bear with me. My childs 1990 Dodge Spirit would not accelerate it seemed ...
  A: That is quite a history! You have to have spark of course, and when you turn the key to the run ...
'99 300M starter replacement/starter circuit short8/28/2008Roland Finston
  Q: My daughter's '99 300M had been getting hard to start--would have to cycle the key numerous times to ...
  A: I hadn't taken into account the positioning of the box, just how it was shown on the page, without ...
'99 300M starter replacement/starter circuit short8/28/2008Roland Finston
  Q: My daughter's '99 300M had been getting hard to start--would have to cycle the key numerous times to ...
  A: You can check out the system without removing the starter. The low current wire from the starter ...
1992 3.0 V-6 no start8/28/2008Roland Finston
  Q: I ran out of follow up questions. I did change the plugs, wires, rotor and cap, and Iam aware of the ...
  A: You might want to verify all the connections that you took apart to be sure that something wasn't ...
Cruise Control not working: LH body8/28/2008Roland Finston
  Q: I have power to the cruise light in the car but nothing happens when I press the set button. I ...
  A: Have you checked fuses 1 and 20, just to be sure? The #4 wire at the servo is ground so that is why ...

Page:   1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10  |  Next


Questions by
Active Experts:
KevinRoland Finston 

     
About Us | Advertise on This Site | User Agreement | Privacy Policy | Kids' Privacy Policy | Help
Copyright  © 2008 About, Inc. About and About.com are registered trademarks of About, Inc. The About logo is a trademark of About, Inc. All rights reserved.