| |
You are here: Experts > Home/Garden > Auto Repair > Chrysler Repair > 1991 New Yorker 5th Ave. hesitates on acceleration
Chrysler Repair - 1991 New Yorker 5th Ave. hesitates on acceleration
Expert: Roland Finston - 11/2/2009
Question
This just started about a week ago. The car has approx. 52,000 miles on the v6 and has been kept in great shape. If I keep a very slow acceleration, it will get up to speed, but if I do what could be considered a normal acceleration, it will hesitate and "cough and sputter" but eventually get up to speed. I have some "shade tree" type of mechanical experience, so depending on the severity of the problem would like to fix it myself. Thank you ahead of time for taking the time to help me with this problem. I do appreciate it!
Answer
Hi Rob,
It is probably a mixture problem but to start you could check for fault codes using the ignition switch:"on-off-on-off-on and leave on" doing that in 5 seconds or less elapsed time. Then watch the check engine light, which remains 'on', to see it begin to flash, pause, flash, etc. Count the number of flashes before each pause. Then repeat to be sure of a repeatable set of count numbers. Group the counts in pairs to form the two-digit fault codes. The last code is always 55 which means 'end of readout'. Let me know the other codes or go to www.allpar.com/fix/codes.html for a code translation.
A possible cause, which may not show up as a fault code is the egr valve being sticky in its action and in fact sticking slightly ajar which leans out the mixture too much for acceleration conditions. The valve is located near the throttle body air intake at the end of the engine, mounted in pipe that recirculates exhaust gas from the rear cylider bank exhaust pipe back around to the intake manifold. The exhaust gases have some fumes that can plate out a crud on the valve stem and thus keep it from closing tight when you are at idle. That makes for a too lean mixture so the engine stalls. The valve proper is mounted horizontally with the stem visible in a space between the body of the valve mounted on the pipe and the round top of the valve which is flanged and so if you look carefully you will see a metal rod (stem of the valve) with a slot around its circumference. You can take the tip of flat blade screwdriver and insert it in the slot and then lever the valve back and forth to check if it is moving freely (against spring action in one direction) or not. If it doesn't seem to close easily with the help of the built-in spring, then I would spray the base of the stem with solvent from a pressure can (such as WD-40 or carb cleaner) while moving the stem back and forth. Then see if that solves the issue.
The last suggestion would be to clean the throat, both sides of the butterfly valve plate, and side idle air passage of the throttle body, using a solvent to remove crud build-up. That too can affect mixture.
I think one of these approaches will bear fruit.
Roland
Add to this Answer Ask a Question
|
|
