AboutRoland Finston Expertise I specialize in Chrysler Corp. front wheel drive cars and minivans for the years 1982-2005 based upon my 50-year DIY experience and factory shop manuals. I don't have expertise/manuals for Jeeps, Trucks, Imports. Today on vacation, I will not take questions at any time, nor answer you within 1/2 hour. If I am shown as "maxed out" try again, in an hour, as I may be answering another question or otherwise busy. There are answers to ten thousand Chrysler questions at your finger tips: put a few key words in the "find" box (above) or click on "view past answers".
Question Roland,
I'm wondering if the clutch pulley be removed from the AC compressor on a 2000 Chrysler Sebring convertible JXi?
Thanks,
Paul
Answer Hi Paul,
There are a couple of theaded holes in the plate on the end into which you insert 6 mm bolts and tighten them in place, then put two box end wrenches on the bolt heads and use the wrenches side by side to grip the plate to prevent it from turning while you remove the compressor shaft nut. Then lightly tap on plate with a plastic hammer to remove the plate and some shims. Use a snap ring pliers to remove the ring that holds the pulley on, and the pulley should then come off.
Roland
