You are here:

Classic/Antique Car Repair/1966 CHEV CONVERTIBLE TOP

Advertisement

Expert: Paul Wilczynski - 11/18/2009


Question
MY 1966 CHEV CONVERTIBLE TOP GRINDS OR MAKES ALMOST A RATCHETING NOISE WHEN I TRY TO PUT IT DOWN.. I ONLY TRIED ONCE...SOMEONE MENTIONED FLUID? I AM AN ALL THUMBS GUY..THANX!

Answer
The top mechanism uses a hydraulic pump and two rams, located tat the rear and on either side of the rear seat.

There should be a fill plug on the pump motor. Remove it and fill with Type "A" transmission fluid until it's about 1/4" below the fill hole. The top should be in the down position when you do this, as the rams will be fully retracted.

Good Luck!

--Paul

Classic/Antique Car Repair

All Answers

Answers by Expert:

Ask Experts

Volunteer

Paul Wilczynski

Expertise

Most questions involving vintage car restoration, mechanical and body, paint and upholstery. Parts sourcing. Extensive experience in wood-bodied station wagons, British and French cars of the '40s through '70s. Rolls-Royce Silver Shadow, Sunbeam Alpine and Tiger, Citroen Maserati, VW Beetle, 1955-65 Chevrolet (especially Nomad station wagons), Corvair.

Experience

Wide-ranging and long-term. I owned a restoration shop in the 1970s, continue to dabble in vintage exotics. At one time, had a seven-car collection of contemporary exotics which I had restored and maintained myself. When I was 18 years old, I designed a woodie kit for the VW Beetle, which I developed into a product which was featured on television and in over 100 magazines and 25 books at last count. I still own and drive one of my creations. I owned a design and fabrication consultancy from 1982-2002, specializing in show car fabrication for manufacturers including Ford, Mazda, GM, Subaru, Mitsubishi, etc. Since 2003, I have been a department manager in Industrial Design, and a full-time instructor in automotive design and fabrication at the university level. My students go on to design automobiles as staff designers for major auto manufacturers worldwide.

Organizations
Western Automotive Journalists, Industrial Design Society of America.

Publications
Long list of magazines and books, including Playboy, VW Trends, VW Greats, Hot VWs, and European automotive magazines.

Education/Credentials
I teach design and fabrication at university level. My education is in Industrial Design, University of Illinois (1966-1970).

Awards and Honors
Many awards for restorations in local concours and shows.

Past/Present Clients
Mazda, Ford, GM, Subaru, Mitsubishi, Honda, Toyota, Chrysler, Mercedes, Porsche.

©2012 About.com, a part of The New York Times Company. All rights reserved.